SivoiaÂ® QS roller 100TM ceiling mount Installation Instructions - Lutron

More documents

Recommendations

Info

9Secure and check the shade9.1Use the programming stylus to run the shade up and down using the adjustmentbuttons ( ), re-level if needed.NOTICE: Pay careful attention to the shade roll up to ensure that it does nottelescope extremely to one side or the other.Tip: Slight telescoping is normal. However, if the shade is telescoping severely to oneside and it is level, press the “close limit” button ( ), and lower the shade all the waydown using the adjustment buttons ( ). Place a piece of tape on the side of the tubethat the fabric is telescoping away from. When finished press the “close limit” button ( )once. This technique is referred to as “shimming”. The shade will always track towardsthe side that the tape (shim) is placed on.direction of fabric telescopingtape(shim)Shim Shim will will correct correct telescoping byby moving fabric this wayPage 11Sivoia® QS roller 100TM Ceiling Mount Installation instructions
10 Setting limits from the EDUSetting the open limit from the EDUThe open and close limits define the top and bottom of the shade, and are used to determinewhich direction the shade must turn in order to raise or lower. Refer to the keypad instructionsheet to set the limits remotely.10.1Tap the “open limit’ button( ). The green LED on theroller 100 EDU will turn on steady,indicating that the EDU is in“Set open limit mode.”Green LEDTap theopen limit button10.2Adjust the position of the EDU tothe desired open limit using theclockwise and counterclockwisebuttons ( ).Use thecounterclockwiseand clockwisebuttons to movethe EDU10.3Press and hold the “open limit’button ( ) for 5 seconds. Thegreen LED on the roller 100 EDUwill flash for 2 seconds, then godark, indicating that the currentposition has been stored as theopen limit.Flashing green LEDPress and hold theopen limit buttonfor 5 secondsPage 12Sivoia® QS roller 100TM Ceiling Mount Installation instructions
Page 1 and 2: Sivoia® QSroller 100TMceiling moun
Page 4 and 5: 1Confirm system dimensions1.1Compar
Page 7 and 8: 4Wire 4-pin terminal block4.1Strip
Page 9 and 10: 6Center and secure shade6.1Move the
Page 11: 8Connect terminal blocks8.1Plug 4-p
Page 15 and 16: 11 Verify limits11.1 Verify the ope
Page 17 and 18: 13 Programming | restoring default
Page 19 and 20: Notes:Page 18Sivoia® QS roller 100
Page 21 and 22: Notes:Page 20Sivoia® QS roller 100
Page 23 and 24: Limited WarrantySCOPEThis limited w

SivoiaÂ® QS roller 100TM ceiling mount Installation Instructions - Lutron

Create successful ePaper yourself

Delete template?

Save as template?