LEGION HK Dis and Re-Assembly Tech.pdf - Bonerepmedical.com

More documents

Recommendations

Info

4. Remove the remaining linkage components (PostSleeve, Hyperextension Stop, and Link Assembly)within the intercondylar box (Figure 9).Figure 95. To remove a Guided-Motion Insert, use the3.5mm Hex Driver to remove the Insert LockingScrew (Figure 10).Figure 108
Implant linkage assembly1. Install the Hyperextension stop and the Linktogether in the direction and orientation shownin Figure 11.Note: the trial axle can be inserted from either side.Figure 112. Install the Hyperextension stop and Link assembly inthe cruciate gap of the femoral noting the directionand rotation of the assembly as shown in Figure 12.Figure 129
Page 1 and 2: Surgical TechniqueHinge Disassembly
Page 4 and 5: Preoperative evaluationThe preopera
Page 6: ExposureExposure of the revision to
Page 9: There are two options for removal o
Page 13 and 14: If the opposite side is accessible,
Page 15 and 16: Component assemblyTibial insert ass
Page 17 and 18: 10. Insert the Sleeve through the L
Page 19 and 20: 15. In a vertical position, use the

LEGION HK Dis and Re-Assembly Tech.pdf - Bonerepmedical.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?