Safe-T-Cable - Pan Pacific Electronics

It’s a Matter of Choice…Over 50 years of success in the design, production, and support of tooling for high-reliability applications in the aircraft andaerospace industry is the reason DMC was included in the development team for Safe-T-Cable ® . The Tooling, which was initiallydesigned to meet the challenges of Safe-T-Cable ® installation, has evolved into a product line that is flexible enough to meetthe users’ exact needs. It’s your choice as to which model and accessories to specify, but always with the understanding thatinterchangeability, adjustability, and overall reliability was the basis of each application tool series.Adjustable TensionHand Tool SeriesThe most popular hand operated application tool forSafe-T-Cable ® is the SCTR Series Adjustable TensionTool. The tool features replaceable noses of variouslengths (see chart on page 14), and a rotary tensionmechanism which can be adjusted to precise cabletension requirements. The tension will repeat atthe setting which has been selected for reliableSafe-T-Cable ® installations.Pre-Set TensionHand Tool SeriesIn some factories where control of tool adjustmentsare not possible, where the skill level is minimal, orapplications where a single-handed operation of the toolis desirable, the SCT Series Application Tool may bethe best choice. All tools in this series feature a tensionlockmechanism, which allows single-handed use of thetool (after the cable is threaded through and into the tool).Multiple actuations of the tool handle will draw the cableinto the tool until all slack is removed from the cable.When the tool senses the correct tension (pre-set atthe factory), it will shift into the crimp-cut mode, andcomplete the installation of the Safe-T-Cable ® on thenext closure of the handle. It’s as simple as that.Pneumatic ApplicationTool SeriesWhen ergonomics and production demands are criticalissues, the DMC SCTPR (No. 3) and SCTP (No. 4) SeriesPneumatic Application Tool are a must. Safe-T-Cable ® isthreaded through the fasteners, into the ferrule, and intothe tool in the same fashion as the manual tools, butthe push of a button is all that is necessary to completethe termination. The tool automatically applies tension(adjustable), crimps and cuts flush in one actuation ofthe trigger. These tools operate on standard shop airpressure, and may be suspended from a load balancerfor an even greater improvement in ergonomics.Application ToolsBattery PoweredTool SeriesThe DMC SCTE Series Battery PoweredSafe-T-Cable ® tool is an ergonomic alternative tothe other Safe-T-Cable ® Application Tools wherea portable tool, without a hose or cord is required.The self contained hydraulic crimp system is reliableand the tool accommodates the same changeablenoses and other accessories that are interchangeablewith other DMC Safe-T-Cable ® Application Tools.© Copyright 2006 Daniels Manufacturing Corp., Orlando, FL • Phone 407-855-6161 • Fax 407-855-6884 • E-Mail: dmc@dmctools.com • www.dmctools.comPAGE 13