Electrical - Paynes Marine Group

Electrical 197VictronMULTIPLUSPURE SINE-WAvE INvERTER / CHARGERSMulti-functional:The MultiPlus is a powerful true sine wave inverter, a sophisticated battery charger that featuresadaptive charge technology and a high-speed AC transfer switch in a single compact enclosure.Unique PowerAssist feature:The MultiPlus will prevent overload of a limited AC source. First, battery charging will automatically bereduced when otherwise an overload would occur. The second level will boost the output of a generatoror shore side supply with power taken from the battery.Uninterrupted AC power (UPS function):In the event of a grid failure or shore or generator power being disconnected, the inverter within the Multiis automatically activated and takes over the supply to the connected loads. This happens so fast (lessthan 20 milliseconds) that computers and other electronic equipment will continue tooperate without disruption.virtually unlimited power thanks to parallel operation:Up to 6 Multi’s can operate in parallel to achieve higher power output. Three phase or split phaseoperation is also possible. Please check our datasheets to see which models have paralleling,three-phase and split phase capabilities.Four stage adaptive charger and dual battery charging:The main output provides a powerful charge to the battery system by means of advanced adaptive charge software that fine-tunes the threestage automatic process to suit the condition of the battery, and adds a fourth stage for long periods of float charging. In addition to this, the Multiwill charge a second battery using an independent trickle charge output intended for a main engine or generator starter battery.ContinuousInverter output (Peak) Inverter input Charger Amps/Banks Transfer switch Dimensions (H x W x D)CMP122020100 2000W / (4000W) 9.5-17 VDC 80A / 2 Bank 30Amp 520x255x125mmPMP123021100 3000W / (6000W) 9.5-17 VDC 120A / 2 Bank 30Amp 362x258x218mmPMP243021100 (24V) 3000W / (6000W) 19-33 VDC 70A / 2 Bank 30Amp 362x258x218mVictronDIGITAL MULTI CONTROL PANEL GXThis panel is intended both for Multi’s and Quattro’s. It allows PowerControl and PowerAssist currentlimit setting for two AC sources: a generator and shore-side current for example.The brightness of the LED’s is automatically reduced during night time. Easy mounting: the includedmounting frame allows the user to mount the panel from either front or back side with the includedmounting frame, the mounting holes will not be visible.REC020005000VictronPHOENIX INvERTER CONTROL PANELThis panel is intended for the models equipped with a RS-485 data port It can also be used on a PhoenixMulti when an automatic transfer switch but no charger switch function is desired. The brightness of theLED’s is automatically reduced during night time.REC030001100