Download PDF instructions for The Micro-light Petrol Tiller/Cultivator

TROUBLESHOOTINGPROBLEM CAUSE CORRECTIONWill not start1. Out of fuel2. Engine not CHOKED properly3. Engine flooded4. Dirty air filter5. Water in fuel6. Clogged fuel tank, line7. Loose spark plug wire8. Bad spark plug or improper gap9. Carburetor out of adjustment1. Fill fuel tank2. See TO START ENGINE in Operation Section3. Wait several minutes before starting again4. Clean or replace air filter5. Drain fuel tank and carburetor, fill with fresh fuel6. Remove fuel tank or filter and clean7. Make sure plug wire is seated properly on plug8. Replace spark plug or adjust gap.9. Make necessary adjustmentsHard to startLoss of powerEngine overheatsExcessive bounce/difficult handlingSoil balls upor ClumpsEngine runs butlabours whentilling1. Throttle control not set properly2. Dirty air filter3. Bad spark plug or improper gap4. Stale or dirty fuel5. Loose spark plug wire6. Carburetor out of adjustment1. Engine is overloaded2. Dirty air filter3. Bad spark plug or improper gap4. Stale or dirty fuel5. Water in fuel6. Clogged fuel tank, line7. Loose spark plug wire8. Dirty or clogged muffler9. Carburetor out of adjustment10. Poor compression1. Dirty air filter2. Dirty engine3. Partially plugged muffler4. Improper carburetor adjustment1. Ground too dry and hard2. Depth stakeincorrectly adjusted1. Ground too wet1. Tilling too deep2. Throttle control not properlyadjusted3. Carburetor out of adjustment1. Place throttle control in "FAST" position2. Clean or replace air filter3. Replace spark plug or adjust gap.4. Drain fuel tank and carburetor, fill with fresh fuel5. Make sure plug wire is seated properly on plug6. Make necessary adjustments1. Set depth stake for shallow tilling2. Clean or replace air filter3. Replace spark plug or adjust gap.4. Drain fuel tank and carburetor, fill with fresh fuel5. Drain fuel tank and carburetor, fill with fresh fuel6. Remove fuel tank or filter and clean7. Make sure plug wire is seated properly on plug8. Clean or replace muffler9. Make necessary adjustments10. Contact an authorized service center1. Clean or replace air filter2. Clean cylinder fins, air filter, muffler3. Remove and clean muffler4. Adjust carburetor1. Moisten ground or wait for more favourable soilconditions2. Adjust depth stake1. Wait for more favourable soil conditions1. Set depth stake for shallower tilling.2. Check throttle control setting.3. make necessary adjustments.19