EQ5 Operations Manual - TECO-Westinghouse Motor Company

EQ5 AC Drive Operations ManualFor drives 40HP/CT, 50HP/VT or more, loosen the mounting screws of the digital operator and removeusing the finger holds on the digital operator case (see Fig. 1-3-4).Fig. 1-3-4 Removing the Digital Operator (40HP/CT, 50HP/VT or more)1-4 Carrying and Moving the Product1. Carry the product by the main body.Do not carry the product while holding the cover or parts other than the main body.2. Use a crane or hoist to carry a product equipped with handling hooks.1-5 StorageTemporary StorageTemporary storage of this product must meet those conditions listed in Table 1-5-1.ItemAmbienttemperatureStoragetemperatureRelativehumidityAtmosphereTable 1-5-1 Storage EnvironmentSpecifications-10 (14°F) to +50 (122°F)-25 (-13°F) to +65 (149°F) Note15 to 95% Note2Condensation or freezing must not occur asa result of sudden temperature changes.The product must not be exposed to dust, direct sunlight, corrosive gas, oilmist, vapor, or water. There must be a minimum salt content in theatmosphere. Do not store where condensation may occur as a result ofsudden changes in temperature.Note1: The storage temperature applies only to short periods of time such as when transportingthe equipment .Note2: As a large change in temperature within this humidity range may result in condensation or freezing,do not store where such temperature changes may occur.1. Do not place this product directly on a floor.2. To store the product in an extreme environment, pack in vinyl sheeting, etc.3. If the product is stored in a high-humidity environment, insert a drying agent (e.g., silica gel)and pack the product in vinyl sheeting._________________________________________________________________________TECO – Westinghouse Motor Company Receiving, Handling, and Storage 3