iG5A, product manual - H2flow

• Function group 1LEDdisplayAddressforcommunicationParameter nameF 0 A200 [Jumpcode]F 1[Forward/A201 Reverserundisable]F 2 A202 [Accelpattern]F 3 A203 [Decelpattern]F 4 A204 [Stopmodeselect]F 8 1) A208 [DCBrakestartfrequency]F 9 A209 [DCBrakewaittime]F10 A20A [DCBrakevoltage]F11 A20B [DCBraketime]F12 A20C [DCBrakestartvoltage]F13 A20D [DCBrakestarttime]F14 A20E [Timeformagnetizing amotor]F20 A214 [Jogfrequency]Min/MaxrangeDescriptionFactorydefaultsAdj.duringrun0 ~ 71 Sets the parameter code number to jump. 1 O 4-50 ~ 20 ~ 10 ~ 30.1 ~ 60[Hz]0 ~ 60[sec]0 ~ 200[%]0 ~ 60[sec]0 ~ 200[%]0 ~ 60[sec]0 ~ 60[sec]0 ~ 400[Hz]0 Fwd and rev run enable1 Forward run disableReverse run disable201LinearS-curve0 Decelerate to stop1 DC brake to stop2 Free run to stop3 Power Braking stopThis parameter sets DC brake startfrequency.It cannot be set below F23 - [Startfrequency].When DC brake frequency is reached,the inverter holds the output for thesetting time before starting DC brake.This parameter sets the amount of DCvoltage applied to a motor.It is set in percent of H33 – [Motor ratedcurrent].This parameter sets the time taken toapply DC current to a motor while motoris at a stop.This parameter sets the amount of DCvoltage before a motor starts to run.It is set in percent of H33 – [Motor ratedcurrent].DC voltage is applied to the motor for DCBrake start time before motoraccelerates.This parameter applies the current to amotor for the set time before motoraccelerates during Sensorless vectorcontrol.This parameter sets the frequency forJog operation.It cannot be set above F21 – [Maxfrequency].1) : Only displayed when F 4 is set to 1 (DC brake to stop).Page0 X 7-100 X 7-150 X5.00 X0.1 X50 X1.0 X50 X0 X7-208-268-18-20.1 X 8-1510.00 O 8-35-3