iG5A, product manual - H2flow

• Function group 1LEDdisplayAddressforcommunicationParameter nameF59 A23B [Stallprevention select]F60 A23C [Stallprevention level]F611)A23D[WhenStallprevention duringdeceleration,voltagelimitselectF63 A23F [Saveup/downfrequencyselect]F642)A240[Saveup/downfrequency]F65 A241 [Up-downmodeselect]Min/Maxrange0 ~ 730 ~200[%]DescriptionThis parameter stops accelerating duringacceleration, decelerating during constantspeed run and stops decelerating duringdeceleration.DuringDecelDuringconstantrunDuring AccelBit 2 Bit 1 Bit 00 - - -1 - - 2 - -3 - 4 - -5 - 6 -7 This parameter sets the amount of current toactivate stall prevention function during Accel,Constant or Decel run.The set value is the percentage of the H33-[Motor rated current].0~1 In Stall prevention run during deceleration, ifyou want to limit output voltage, select 10 ~ 1 This parameter decides whether to save thespecified frequency during up/downoperation.When 1 is selected, the up/down frequency issaved in F64.If ‘Save up/down frequency’ is selected atF63, this parameter saves the frequencybefore the inverter stops or decelerated.0~2We can select up-down mode among threething0 Increases goal frequency as astandard of Max. frequency/Min.frequency1 Increases as many as stepfrequency according to edge input2 Available to combine 1 and 2FactorydefaultsAdj.duringrunPage0 X 10-3150 X 10-38-260 X 8-40.00 X 8-40 X 8-51) : It is indicated when setting bit 2 of F59 as 12) : Set F63 to 1 to display this parameter.5-7