Pulsar 600 Series - hsa-asia.com

Technical Specification: 600 SeriesOutputsPulsarpoint 600Pulsarpoint 610Pulsarpoint 611 (Intrinsically safe EEx ia IIC T6)Power requirementsOperating temperaturesIngress protection ratingVessel specificationsVessel diameterVessel wall thicknessVessel materialMaximum fluid viscositySize / weightHousing materialCE / EMC Approval1 volt free contact, programmable 1A, 30V dc SPCO4 to 20mA current sink (loop powered)4 to 20mA current sink (loop powered)18-36V dc-40˚C to +90˚CInstallation RecommendationsThe Pulsarpoint units should be mounted in direct contact with the outside wall of the tank, which should be clean and free from anyloose or flaking material. The sensor to tank contact area should be coated with non melting waterproof silicone compound to providea direct acoustic coupling. The supplied self adhesive aluminium plate will firmly position and clamp the sensor in place.Commissioning and set-up are simple and straight forward. The set-up consists of a one button calibration routine to enable setting theoption of wet or dry indication.IP68Greater than 250mm diameter2.5 to 40mmMetal or glass100 centipoiseSize: 118mm L x 70mm H x 65mmWeight: 1kgType 316 stainless steel investment castingComplies with BS EN 50081-1:1992 for emissions & BS EN 50082-2:1995 for immunityBump, shock & vibrationComplies with BS 60068Flammable atmospheres approvalZone ‘O’ EEx ia IIC T6 (Pulsarpoint 611)InstallationBy means of the semi flexible self adhesion type aluminium mounting plate with fasteners ( temperature range -40˚Cto +90˚C) using a silicone grease acoustic coupler applied to the base of the sensor and the tank. Silicone compoundfrom Dow Corning DC-4 or equal.Cable entryM20 x 1.5mm for glandRepeatability & responseRepeatability± 1.0mmMinimum response time1.0 secondVariable alarm hold off1 to 255 secondsRepresented byCertificate No: 950136Our policy is one of constant development and improvement. Pulsar reserve theright to amend technical details as necessary.LP 07.05. 600