LD STINGER SERIES - Notape

More documents

Recommendations

Info

ACTIVE SYSTEMS FEATURES:ENGLISHDEUTSCHFRANCAIS12 POWERThe power LED lights up green when the device is turned on. The red Clip-LED starts blinking when theamplifier reaches its clipping threshold. This should be avoided, to do so, reduce the master level (controlnr. 7 on the diagram) until the LED stops blinking.13 VOLEX POWER PLUGSpecial lockable mains socket (Volex Power Plug). Connect an IEC plug to this socket. The Fuse can be foundin the little compartment directly below this socket. To change fuses, pull out the little drawer. You will findtwo fuses, one is in use and the other spare.IMPORTANT NOTE: Only use suitable fuses. Never bridge the fuse contacts.14 POWER SWITCHMains switch. Before switching on the power to the unit, all level controls should be set to minimum. Otherwise, microphones already connected to the system may cause undesired feedback.15 SPEAKON OUTPUTThis additional speaker output (no impedance < 8Ω) is split out from the amplification unit. That means youcan connect a passive speaker (e.g. the passive version of this speaker, the <strong>STINGER</strong> 12) to this output andthus drive two speakers with a single amplifierunit.FRANCAIS POLSKIFRANCAIS español8
PASSIVE SYSTEMS FEATURES:1 SPEAKON INPUT2 SPEAKON OUTPUTThe input signal is loopedthrough to this output.DEUTSCHENGLISH1FRANCAISINPUTOUTPUT12” / 1” Multifunctional Cabinet350 W RMS / 8 Ω2FRANCAIS POLSKIFRANCAIS español9
Page 1: USER´S MANUALBEDIENUNGSANLEITUNGMA
Page 4 and 5: PREVENTIVE MEASURES:ENGLISHDEUTSCH1
Page 6 and 7: ACTIVE SYSTEMS FEATURES:MICINMIC GA
Page 10: SPECIFICATIONS PASSIVE:8 “ PASSIV
Page 13 and 14: MANUFACTURER´S DECLARATIONS:LIMITE
Page 15 and 16: WEEE-DECLARATIONYour LD-Systems pro

LD STINGER SERIES - Notape

Create successful ePaper yourself

Delete template?

Save as template?