Range Rover Workshop Manual - System Description and Operation ...

More documents

Recommendations

Info

ENGINE – TD6The valve springs are made from spring steel and are of the parallel single-coil type. The bottom end of each springrests on the flange of a spring retainer which has an integral valve stem seal. The top end of the spring is held in placeby a spring retainer which is held in position at the top end of the valve stem by split taper collets. The taper colletshave grooves on the internal bore that locate to grooves ground into the upper stems of the valves.Valve seats and valve guides are an interference fit in the cylinder head.Hydraulic Lash Adjusters and Roller Finger RockersThe valves are operated through roller-type finger rockers and hydraulic lash adjusters, actuated by the camshaftlobes. When the camshaft lobe presses down on the top of a finger rocker, roller mechanism, the respective valve isforced down, opening the affected inlet or exhaust port. The use of this type of actuation method helps reduce frictionin the valve timing mechanism.The body of the hydraulic lash adjusters contains a plunger and two chambers for oil feed and pressurised oil. Thepressurised oil is supplied to the lash adjusters via the main oil galleries in the cylinder head and through a hole in theside of the lash adjuster body. The oil passes into a feed chamber in the lash adjuster and then through to a separatepressure chamber via a one way ball valve.Oil flow from the pressure chamber is determined by the amount of clearance between the lash adjuster outer bodyand the centre plunger. Oil escapes up the side of the plunger every time the lash adjuster is operated, the downwardpressure on the plunger forcing a corresponding amount of oil in the lash adjuster body to be displaced. When thedownward pressure from the camshaft and finger rocker is removed (i.e. after the trailing flank of the camshaft lobehas passed), oil pressure forces the lash adjuster's plunger up again. This pressure is not sufficient to effect the valveoperation, but eliminates the clearance between the finger rocker and top of the valve stem.Electronic Fuel InjectorsThere are six electronic fuel injectors (one for each cylinder), each located in the centre of a cylinder's four valves.The electronic fuel injectors are supplied with fuel from the fuel rail and deliver finely atomised fuel directly into thefuel chambers.For more information on the Fuel injector operation, refer to the Engine Management – Td6 section of this workbook.Ancillary Components and Belt DrivesThe ancillary components, which comprise the torsional vibration damper, alternator, A/C compressor, steering pumpand water pump, are driven by the engine crankshaft via the ancillary drive belts.The belts, which are maintenance free poly-V type belts, are automatically pre-loaded by the tensioning rollers andare routed over deflection pulleys in order to maintain sufficient adhesion about the drive wheels. This ensures slipfreedrive of the ancillary components.DESCRIPTION AND OPERATION 12-1-11
ENGINE – TD6Belt Drive1234756M12 776321 Water pump2 Tensioning pulley3 Power steering pump4 Alternator pulley5 Idler pulley6 Torsional vibration damper7 A/C compressorTorsional Vibration DamperThe torsional vibration damper with decoupled belt pulley suppresses longitudinal vibration and reduces noise. It ismounted to the forward end of the crankshaft with 4 central bolts torque loaded to 45 Nm.Tensioning PulleyThe tensioning pulley or idler pulley is a spring-loaded element.LubricationThe lubrication system is a wet sump, pressure fed type. It lubricates the engine sliding surfaces, dissipates heat,absorbs fuel combustion residue and seals off the gap between the cylinder and piston.12-1-12 DESCRIPTION AND OPERATION
Page 2: ENGINE - TD6ENGINE DESCRIPTION - Td
Page 6 and 7: ENGINE - TD6Oil Pressure SwitchThe
Page 8: ENGINE - TD6Camshaft Timing Compone
Page 11: ENGINE - TD6Cylinder Head GasketThe
Page 15 and 16: ENGINE - TD6The oil pump is driven
Page 17 and 18: ENGINE - TD6Hydraulic Engine Mount6
Page 19: ENGINE - TD6Vacuum SupplyDistributo

Range Rover Workshop Manual - System Description and Operation ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?