Manual - One Stop Rental

More documents

Recommendations

Info

9 STORAGE9.1 STORAGE INSTRUCTIONS! WARNINGTo prevent possible explosion or ignition ofvaporized fuel, do not store unit in enclosurewith open flame (Example: furnace or waterheater pilot light).Before the unit is put into storage for any period exceeding30 days, the following steps should be taken:1. Drain all fuel from fuel tank and fuel lines.2. Start and run engine until all fuel is used from carburetorfloat bowl.3. While engine is still warm, drain the crankcase oiland replace with the proper weight oil correspondingto the season the equipment will next be used.4. Remove the spark plug and squirt a small amount ofengine oil into the cylinder. Pull the starter a fewtimes to coat the cylinder with the oil. Reinstall thesparkplug.5. Lubricate all lubrication fittings.6. BE SURE the water tank has been drained.To put unit back into operation after extended storage:• Check for loose or broken parts and tighten orreplace as necessary.• Check for cracked, bent or broken tines and replaceas necessary.• Fill fuel tank with fresh fuel.• Check oil levels in crankcase and gear reductioncase (with unit in level position).• Start engine and check for fuel leaks.• Repair any fuel leaks immediately.• Check clutch lever operation to be sure unit stopswhen clutch lever is released.10
TORQUE CHART 10TORQUE SPECIFICATIONSHEX HEAD CAP SCREWSThe torque values shown should be used as a general guideline when specific torque values are not given.U.S. Standard HardwareGradeSAEgrade5∗SAEgrade8∗∗FlangelockScrew w/FlangelockNutShank Size (Diameter in inches, fine or coarse thread)1/4 5/16 3/8 7/16 1/2 9/16 5/8 3/4 7/8 1 1 1/8ft.-lbs. 9 18 31 50 75 110 150 250 378 583 782N·m 12 24 42 68 102 150 203 339 513 790 1060ft.-lbs. 13 28 46 75 115 165 225 370 591 893 1410N·m 18 38 62 108 156 224 305 502 801 1211 1912ft.-lbs. 24 40N·m 33 54∗ Grade 5 marking –Minimum commercial quality (Lower quality not recommended).∗∗ Grade 8 marking –Metric Standard HardwareGradeGrade8.8∗Grade10.9∗∗Grade12.9∗∗∗Shank Size (Diameter in millimeters, fine or coarse thread)M4 M5 M6 M7 M8 M10 M12 M14 M16 M18 M20 M22 M24 M27ft.-lbs. 2 4 7 11 18 32 58 94 144 190 260 368 470 707N·m 1.5 3 5.2 8.2 13.5 24 43.5 70.5 108 142 195 276 353 530ft.-lbs. 3 6 10 16 25 47 83 133 196 269 366 520 664 996N·m 2.2 4.5 7.5 12 18.8 35.2 62.2 100 147 202 275 390 498 747ft.-lbs. 3.6 7 11 20 29 58 100 159 235 323 440 628 794 1205N·m 2.7 5.2 8.2 15 21.8 43.5 75 119 176 242 330 471 596 904∗ Grade 8.8 marking – ∗∗ Grade 10.9 marking – ∗∗∗ Grade 12.9 marking –8.8 10.9 12.911
Page 1 and 2: TECHNICAL MANUAL(Safety, Operation,
Page 3 and 4: TABLE OF CONTENTSPage1 General Info
Page 5 and 6: SPECIFICATIONS 33.1 SPECIFICATIONSD
Page 7 and 8: SET-UP 49. Connect clutch cable to
Page 9 and 10: OPERATION 66.1 OPERATIONPre-operati
Page 11: MAINTENANCE 88.1 MAINTENANCE!WARNIN
Page 15 and 16: AERATOR & DRIVE GROUP 11.1UNITS BUI
Page 17 and 18: (CONT’D.) AERATIOR & DRIVE GROUP
Page 19 and 20: AERATOR & DRIVE GROUP 11.2UNITS BUI
Page 21 and 22: (CONT’D.) AERATOR & DRIVE GROUP 1
Page 23 and 24: CONTROLS & HANDLE 11.3UNITS BUILT A
Page 26: 11.5 HEIGHT ADJUSTER & TRANSPORT FR
Page 29 and 30: HEIGHT ADJUSTER & TRANSPORT FRAME 1
Page 31 and 32: DECALS 11.7Ref.No.PartNo.No. Descri
Page 33: LAWNAIRE IVANDLAWNAIRE VVIDEOEASY T
Page 36 and 37: WARRANTY SERVICETo make a claim und
Page 38 and 39: PART NUMBER INDEXPartPageNo.No.0090

Manual - One Stop Rental

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?