Manual - One Stop Rental

SET–UP 49. Connect clutch cable to clutch spring and spring toclutch handle. See Figure 4.111. Unwrap throttle cable from engine. Hook cable endinto throttle lever on right side of clutch handle.Install cable clamp as shown in Figure 6, do nottighten clamp. Attach spring to throttle lever andbracket.NOTE: To prevent spring from rubbing against handlebracket, spring must be installed as shown inFigure 6.2FIGURE 41. Clutch Handle2. Clutch Spring1210. Hook ball end of clutch cable into the cable clip onbellcrank (See Figure 5). Adjust position of cable clipso that when the clutch handle is pulled back, and theidler pulley fully engages the drive belt, the clutchspring is extended approximately 3/8” (9.5 mm).Release clutch handle and make sure the drive beltis disengaged.3443312FIGURE 61. Throttle Lever2. Spring3. Throttle Cable Clamp3FIGURE 51. Clutch Cable2. Cable Clip3. Bellcrank381812. Pull clutch handle all the way back and push throttlecable forward until throttle lever on engine is fullyadvanced, then tighten the throttle cable clamp.13. Inflate tires to maximum pressure indicated on tirefor best performance and ease of operation.5