Tracking, Tracing and Data Acquisition Equipment

CITC Technical SpecificationDocument Number: RI080Revision: Issue 1Date:10/01/2010 GSpecification for Tracking, Tracing andData Acquisition EquipmentIssued by The Communications and Information Technology Commission of SaudiArabia in accordance with article 89 of the Telecommunications Bylaw.Communications and Information Technology CommissionKing Fahad HighwayRiyadhTelephone: + 966 1 461 8050Fax: + 966 1 461 8150E-mail: info@citc.gov.saWebsite: www.citc.gov.saDocument Number: RI080 Issue 1 10/01/2010 GPage 1 of 3This publication is a translation. In case of divergence; the original Arabic text shall prevail.

ContentsThis document comprises the following sections:Scope............................................................................................................... 2Entry into force ............................................................................................... 2Proof of compliance........................................................................................ 2Technical requirements................................................................................... 2Obtaining technical standards......................................................................... 3Network information (only for network interfaces) ....................................... 3Document history............................................................................................ 3ScopeThis document applies to Tracking, Tracing, Data Acquisition.All telecommunications and radio terminal equipment must comply with therelevant technical specifications established by CITC. In addition, suchequipment may be subject to regulations for Declaration of Conformity orregistration. See http://www.citc.gov.sa/ for details.If more than one interface type is offered by a piece of equipment, eachinterface must meet the applicable technical specifications.Entry into forceThis specification shall enter into force on 10/01/2010 GProof of complianceIt is recommended that test reports are obtained from a laboratory that hasbeen accredited by a body that is a member of the ILAC Mutual RecognitionArrangement.Technical requirementsEN 300 220-2Electromagnetic compatibility and Radio spectrum Matters (ERM) — ShortRange Devices (SRD); Radio equipment to be used in the 25 MHz to1 000 MHz frequency range with power levels ranging up to 500 mW;Part 2: Harmonized EN covering essential requirements under Article 3(2) ofthe R&TTE directive.EN 301 489-1Document Number: RI080 Issue 1 10/01/2010 GPage 2 of 3This publication is a translation. In case of divergence; the original Arabic text shall prevail.

Electromagnetic compatibility and Radio spectrum Matters (ERM);Electromagnetic Compatibility (EMC) standard for radio equipment andservices; Part 1: Common technical requirements.EN 301 489-3Electromagnetic compatibility and Radio spectrum Matters (ERM);Electromagnetic Compatibility (EMC) standard for radio equipment andservices; Part 3: Specific conditions for Short-Range Devices (SRD)operating on frequencies between 9 kHz and 40 GHz.GeneralIn addition to meeting the above requirements, all equipment must complywith the requirement of CITC specifications GEN001, be safe and must notadversely affect other electrical equipment.Obtaining technical standardsETSI technical standards may be obtained free of charge for individual usefrom the ETSI website www.etsi.org..Network information (only for network interfaces)Further information on the characteristics and presentation of networkinterfaces can be found by visiting operator's website.Document historyDescription Status DateIssue 110/01/2010 GThis publication is a translation. In case of divergence; the original Arabic text shall prevail.Document Number: RI080 Issue 1 10/01/2010 GPage 3 of 3This publication is a translation. In case of divergence; the original Arabic text shall prevail.