maxicut 600 - Twose

5299 5. INSTALLATION 0306WARNINGFailure to adjust the drawbar to the CORRECT LENGTH, failure to PROVIDEDRAWBAR CLEARANCE sufficient for short turns and/or failure to ATTACH CLEVIS TOTHE DRAWBAR correctly and securely MAY ALLOW THE MOWER TO SEPARATEFROM TRACTOR AND/OR THE DRIVELINE HALVES TO SEPARATE WHICH CANCAUSE SERIOUS BODILY INJURY OR DEATH TO THE OPERATOR OR OTHERS.PARKING JACK ADJUSTMENTThe tongue hitch is equipped with jack mounting which can be rotated approximately 15 degrees ineach direction so that jack may always be positioned in a near vertical position. (See fig 5) Loosen nutA, install parking jack and then rotate until jack is vertical. Tighten nut A. Always ensure that pin B isengaged in the location holes to prevent jack detaching from mounting.PINTLE HOOK HITCH OPTIONDrawbar length must be modified to obtain dimension “A”, CV driveline = 430mm ± 50mm (17” ± 2”)).Use driveline length check procedure in manual to ensure problems do not occur. (See Fig 6).PTO SHAFTWith the machine attached to the tractor’s drawbar, proceed to connect the PTO as follows:1 Slide the collar back and simultaneously push driveline yoke into PTO shaft on tractor untilengaged.2 Move yoke back and forth to make sure yoke is locked in plate. (QS-type collars will rotate 360ºwhen balls are correctly located.).WARNINGA loose yoke could slip and cause personal injury or damage to mower. When attachingdriveline yoke to tractor PTO shaft, it is important that the slide collar is fully forward andseated on yoke.Due to many different makes and sizes of tractor to which mowers may be fitted, a nominal length PTOshaft is supplied with the machine. In some cases it may be found that this PTO shaft is too long and willhave to be shortened.5 - 2