maxicut 600 - Twose

5299 5. INSTALLATION 0306The control valve handles should be set in the float position for most mower operations. This will allowthe mower sections to follow the contour of the land. In the float position, the control valve handles arepushed in closest to the valve body. The closed-centre valve handles must be kept in the float positionto keep the wings and centre section from creeping up. When extending the left or right wing out overa ditch when mowing, put the control valve handles with detents in the centre position on the valve.This will give the mower more stability and prevent the opposite wing from raising. Do not operatemower in this position over rough terrain or for long periods of time.Keep hoses and couplings free from contamination. Never leave a disconnected end of hose open.Be sure the hoses are supported by the two hose brackets and are not allowed to come into contactwith drivelines.In case of valve or cylinder malfunction, contact your local dealer. If it becomes necessary to removethe piston from the cylinder, apply a few drops of “Loctite No 227” to nut before replacing.CLUTCH ADJUSTMENT3 slip clutches are fitted to protect the blades, drivelines, gearboxes, tractor etc. Machines are suppliedset to a low torque and clutches should be adjusted prior to first use, as detailed in MaintenanceSection.5 - 4