OPERATION MANUAL MBM 206M Manual Paper Folder - Ideal-MBM

More documents

Recommendations

Info

(7) Maintenance1 Before cleaning the machine, be sure to set POWER to the OFF position and unplug the power cord fromthe outlet.2 When the unit is not in use, put the machine cover in place to prevent dust, paper particles , etc. fromaccumulating on the fold rollers.3 If paper particles, dust, ink, etc. accumulate on the fold rollers; it may cause the paper to fold improperly.Clean the rollers periodically to prevent this occurrence.4 If paper particles, dust, ink, etc. accumulate on either the paper feed rubber roller or the paper separator,paper feed performance deteriorates, causing pap er to slip and possibly jam. Clean the rubber roller andseparator periodically to prevent this occurrence.5 Periodically clean the paper feed tires to prevent marking.6 Consumable products include: Paper feed rubber roller, rubber brake, and paper feed separator.15
(8) TroubleshootingTrouble Possible Cause MeasuresThe paper doesnot feed properlyPaper sticks just after it is printedStains on the paper separatorStains on the paper feed rubberrollerThe paper separator is worn outJog the paper sufficiently. Make sure thatthe ink is dry.Clean the paper feed separator usingapproved cleaner.Clean the dust or ink on the paper feedroller with approved cleaner.Install a new paper separator.The volume of the paper stacked onthe paper feed table is not enoughAdd more paper to the feed table – at least20 sheet or more.The machine does notoperate even after theSTART/STOP key ispressedWrinkles appear onthe paperImproper foldpositionPrinted paper(13# or lighter)cannot be foldedPaper jam inside the unitPaper sticks just after it is printedStains on the paper separatorStains on the paper feed rollerStains on paper fold rollersTable 1 and 2 are not properly setPaper jam in Table 1 and 2The total length of the paper is notstandard sizeThe surfaces of the fold rollers arecovered with dust or ink, causingthem to be slipperyLow room temperatureDetach Table 1 and 2 and remove thepaper from the unit.Jog the paper sufficiently. Make sure thatthe ink is dry.Clean the paper separator using theapproved cleaner.Clean the dust or ink on the paper feedroller with the approved cleaner.Clean all four fold rollers using approvedcleaner.Reset properly.Detach Table 1 and 2 and remove thejammed paper.Measure the total length of the paper andadjust using the fine adjustment knob.Clean all four fold rollers using theapproved cleaner.Operate the machine in aclimate-controlled environment. Papershould be a room temperature beforefolding. Paper stored below 53F is notrecommended.16
Page 6 and 7: (2) AccessoriesMake sure that the f
Page 8 and 9: (4) Designation and Functions of Op
Page 10 and 11: Setting the paper exit roller:The e
Page 12 and 13: Under the following conditions the
Page 14 and 15: Fine Adjustments for Table 1Fold ty

OPERATION MANUAL MBM 206M Manual Paper Folder - Ideal-MBM

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?