Manual Version 2.0 - PROLiNK

More documents

Recommendations

Info

Section Four: Configure the Bridge/RouterClick Enable NAT to internal interfaces and the configuration of PPPoARouter mode has been done.NOTE: Please remember to save the configuration after finishingthe settings.19
Section Four: Configure the Bridge/RouterClick Save Config , then Click Save button and wait until it finishes.4.2.2 PPPoE Routed Configuration.A. Click Router mode under Configuration and choose PPPOE routed.20
Page 1 and 2: Hurricane 8800ADSL Bridge/RouterUSE
Page 3 and 4: The information contained in this m
Page 5 and 6: Section One: Introduction1.3 Equipm
Page 7 and 8: Section Two: Connect the Bridge/Rou
Page 9 and 10: Section Two: Connect the Bridge/Rou
Page 11 and 12: Section Three: Configure the PCsSec
Page 13 and 14: Section Three: Configure the PCs3.2
Page 15 and 16: Section Four: Configure the Bridge/
Page 19: Section Four: Configure the Bridge/
Page 27 and 28: 4.2.4 IPoA Routed Configuration.Sec
Page 29 and 30: 4.4 How to set Port Forwarding.Sect
Page 31 and 32: 4.6 How to Configure Bridge Mode.Se
Page 33 and 34: Appendix A - TroubleshootingAppendi
Page 35 and 36: Appendix B - High ProtocolsAppendix
Page 37 and 38: Appendix B - High ProtocolsBOOTP/TF
Page 39 and 40: Appendix D - EMC and SafetyAppendix
Page 41 and 42: Appendix E - Telecom NoticesMicroso

Manual Version 2.0 - PROLiNK

Create successful ePaper yourself

Delete template?

Save as template?