"MTS Connect" for Mac OS version 1, September

More documents

Recommendations

Info

ENG7.9. Once you click «Connect», the connection will be established.7.10. Once the connection is successfully established, the following screenwill appear.29
ENG7.11. If you want to disconnect network, click «Disconnect».8.8.1.8.2.8.3.Caution (Mac OS X 10.5 (LEOPARD))Never remove AnyDATA modem from PC until the final disconnection, because itcan lead to modem failure or breakage. Make sure the network disconnectionprocess is finished and then remove the modem.If other LAN ports are activated, the message of IP-address verification processcan appear twice. It depends on the type of AnyDATA network equipment.If you try to connect modem to the port other than the installed USB port thesystem will start searching for the new driver.In this case, when the driver installation is completed, you should repeat theaccount information by clicking «+» and following steps 5.4–5.10 of this manual.Unwanted drivers can be removed as follows: choose drivers and click «-»to delete them.30
Page 1: Version: 01, september 2008Install
Page 4 and 5: ENG2.Initial conditions for using M
Page 6 and 7: ENG3.4. When a message is displayed
Page 8 and 9: ENG3.8. Click «Install» or «Upgr
Page 10 and 11: ENG3.13. Tap «Apple» on top menu,
Page 12 and 13: ENG4.4.1.Network Connection (Mac OS
Page 14 and 15: ENG4.5. Click «Show» Popup menu,
Page 16 and 17: ENGClick4.7. «Modem» tab and sele
Page 18 and 19: ENG4.10.Once the connection is succ
Page 20: ENG• Select previously installed
Page 23 and 24: ENG6.6. Once you agree to the terms
Page 25 and 26: ENG6.9.The driver is being installe
Page 27 and 28: ENG7.4.AnyDATA communication device
Page 29: ENG7.7. Click «Advanced» on the b
Page 33: www.mts.com.uawap.mts.com.ua

"MTS Connect" for Mac OS version 1, September

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?