Service Manual - The Expert - Dana Holding Corporation Product ...
Service Manual - The Expert - Dana Holding Corporation Product ...
Service Manual - The Expert - Dana Holding Corporation Product ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Family<br />
(J & W)<br />
Nominal Load<br />
Carrying Capacity<br />
(175 = 17,500 Lbs.)<br />
(190 = 19,000 Lbs.)<br />
(210 = 21,000 Lbs.)<br />
(220 = 22,000 Lbs.)<br />
(230 = 23,000 Lbs.)<br />
GEAR SET IDENTIFICATION<br />
���������������������Date gear set was made.<br />
������������������Company logo and location of<br />
manufacturing facility.<br />
����������Part number of pinion. (TYPICAL)<br />
�������������������������������Indicates the pinion<br />
has 11 teeth and the ring gear has 41 teeth which<br />
results in a 3:73:1 ratio.<br />
��������������������Spicer ring gears and pinions<br />
are manufactured as matched sets. Both ring gear and<br />
pinion are marked with a corresponding number (i.e.<br />
260), which identifies them as a matched set.<br />
A gear set that does not have the same match set<br />
numbers should not be run together. If either ring gear<br />
or pinion require replacement, a new matched set must<br />
be used.<br />
���������������Indicates backlash setting for assembly.<br />
�������������Indicator for proper pinion position shim<br />
stack up. (See�����������������Pg. 15)<br />
MODEL IDENTIFICATION NUMBERING SYS-<br />
TEM<br />
J 175 S N<br />
Gearing Type<br />
(S = Single Reduction)<br />
3<br />
41-11<br />
TOOTH<br />
COMBINATION<br />
SPICER<br />
TRADEMARK<br />
PART<br />
NUMBER<br />
Options<br />
(N = *No-SPIN ® Differential)<br />
HEAT<br />
CODE<br />
* No-SPIN ® is a registered trademark of Tractech<br />
SPICER<br />
TRADEMARK<br />
PINION<br />
ETCH<br />
MFG.<br />
DATE<br />
L10<br />
BACKLASH<br />
ETCH<br />
+15<br />
260<br />
MATCHED<br />
SET NUMBER<br />
260