Ether-FSH2402GT User's Manual

More documents

Recommendations

Info

5 Management Software GuideQos Configuration is used to configure the Qos control registers. Press the Refresh button to read thestatus of the registers. Press the Update button to set the registers.VLAN Configuration SubmenuThis page is used to configure the vlan table registers.Refresh button24Ether-FSH2402GT Gigabit Ethernet Switch User’s Manual V1.0
5 Management Software GuideRead the VLAN table registers. If you can have configured VLAN but it doesn’t show on the table,please press the buttonAdd VLAN buttonClick the ADD VLAN button will pop up a configuration window below. Select port base or tagbase VLAN, then check the port where you want to configure the settings. For Tag Base VLAN,please enter a VLAN ID number.Port Tagging Control buttonPress this button you will see a dialog like follows. To configure a port, please double-click the portyou want to configure.Please make sure to “Save VLAN” after configuration. If the VLAN settings is wrong, it can causeuser not enable to enter the switch’s management. In this case, simply reset the switch to factory’sdefault.Vlan Control SubmenuSetting VLAN Control Registers.25Ether-FSH2402GT Gigabit Ethernet Switch User’s Manual V1.0
Page 3: Table of ContentsTable of ContentsT
Page 6 and 7: Table of ContentsOptions menu......
Page 8 and 9: Table of ContentsTablesTable 2-2 Ca
Page 11 and 12: 1 Product OverviewVLAN membership b
Page 14: 2 Preparation before Installation2
Page 17 and 18: 3 Installation of the Switch3 Insta
Page 19: 3 Installation of the Switch• The
Page 22 and 23: 4 LED Indicators4 LED IndicatorsBef
Page 24: 5 Management Software Guide5 Manage
Page 28: 5 Management Software GuideMIB Coun
Page 31: 5 Management Software GuidePlease s
Page 35 and 36: 5 Management Software GuideSecurity
Page 37 and 38: 5 Management Software GuidePull dow
Page 39 and 40: Appendix A Product Specifications

Ether-FSH2402GT User's Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?