SNR : SNC Pillow Block Housings

More documents

Recommendations

Info

34Insert the pre-mounted shaft into the lower housing section.Carefully insert the labyrinth seals into the sealinggrooves on the lower housing sections. For the floatingbearing version, position the bearing centrally on thebearing seat.Distribute the remaining quantities of grease (table, Page 22)evenly in the lower housing sections.Position the lower housing section correctly using thealignment markings and slightly tighten the foot bolts.Locating ringsFor the fixed bearing version, insert the two locating ringson each side of the bearing in the lower housing section.5 6Position the upper housing section and tighten theconnecting bolts evenly to the tightening torques specifiedin the table on Page 21.Press a round cord into each circular groove between theshaft and the labyrinth ring. Using a screwdriver makes iteasier to insert the cord.Check the alignment of the bearing housing again andthen tighten the foot bolts to the appropriate tighteningtorque (table, Page 21).37
Taconite seal mountingSC..TA1Securely position the lower sections of the housings.38
Page 1 and 2: IndustrySNR : The SNC PillowBlock R
Page 3 and 4: ForewordSNR is one of Europe's lead
Page 5 and 6: Latest generation of SNCpillow bloc
Page 7 and 8: Structural detailsDuring developmen
Page 9 and 10: Markings for mounting with fourfast
Page 11 and 12: Seal versionsSC..DS Double lip seal
Page 13 and 14: Sealing systemsThere are a wide var
Page 15 and 16: Dimensions of supporting rings for
Page 17 and 18: Cover plate SC...ECCover plates are
Page 19 and 20: Bearing arrangement constructionSNC
Page 22 and 23: Loads and torquesThe table below co
Page 24 and 25: Lubricating fitting and lubricant d
Page 26 and 27: Abutment dimensions for B RDC regul
Page 28 and 29: Mounting the bearingsIt is often th
Page 30 and 31: Preparation and important instructi
Page 32 and 33: 34Clamp the shaft horizontally (pro
Page 34 and 35: 4 5Clamp the shaft horizontally (pr
Page 36 and 37: 3 4Insert the pre-mounted shaft int
Page 40 and 41: 2Clamp the shaft horizontally (prot
Page 42 and 43: V-ring sealSC..SV+CoverSC..ECLabyri
Page 68 and 69: Maintenance: SNR lubricating grease
Page 70: SNR : SNC Pillow Block HousingsDesi

SNR : SNC Pillow Block Housings

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?