User Manual [ver 3.00] - Koukaam.se

More documents

Recommendations

Info

Here, you can set up IP Address, Subnet Mask, Default Gateway and DNS Server according to yournetwork parameters. If you do not wish to setup the network parameters manually, you can EnableDHCP to obtain requested parameters automatically from the DHCP server in your network.The parameter Switch delay (x0.1s) specifies delay between triggering two outputs. It avoids overloadingof the device supply by turning all outputs ON at the same time.The selections KSHELL Port and WEB Port allow change of default output for access via telnet,eventually, device web interface.Device name allows you to insert the name of your device for easier identification in the future.Firmware version is just informative and shows the current firmware version.After you make requested changes on this page and click Apply the device will change the parametersand restart automatically. After the restart you will have to login again. Reset To Default buttonrestores factory default settings.Figure 9:5.2.2 E-mail configurationClick Setup e-mail and the form for adjusting e-mail settings can be seen on the right. Please inputsender (From), and recipient (To) of e-mail message. Also input the SMTP server address that will beused to send out the e-mail. The last field (Warning MSG) is used to input the subject of the e-mailmessage sent.Click Apply to save. You can check if e-mail setup is correct by pressing the Send test messagebutton.Note: Current firmware version does not support SMTP authorization.11
Figure 10: Setup e-mail5.2.3 Date and time settingsClick Date & time in the menu and the system date and time settings will appear on the right.NETIO-230B supports two methods of getting the right date and time values. It can be enteredmanually or obtained automatically from the SNTP server.Figure 11: Setup time and date• SNTP enable: Enables time synchronization with SNTP server.• SNTP status: SNTP server synchronization status:• Synchronized: time successfully synchronized with SNTP server• Not Synchronized: time successfully synchronized with SNTP server12
Page 2 and 3: WarningUnauthorized modification of
Page 4 and 5: 1 IntroductionNETIO-230B is a power
Page 7 and 8: Figure 3: device set-upFigure 4: se
Page 9 and 10: Figure 6: manual controlnot, the de
Page 11: • OFF time: Date and time to swit
Page 15 and 16: 5.2.5 Firmware updateThe page Firmw
Page 17 and 18: Each communication session via KSHE
Page 19 and 20: • - Interval (in seconds) in whi
Page 21 and 22: quit= quit Logout. Return value is

User Manual [ver 3.00] - Koukaam.se

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?