SERVICE MANUAL - diagramas.diagram...

REMOVING AND REINSTALLING THE MAIN PARTSTAPE MECHANISM SECTION(A1)x1(A1)x1ø2x3mmPerform steps 1 to 6 and 8 of the disassembly method toremove the tape mechanism.How to remove the record/playback and eraseheads (TAPE 1) (See Fig. 7-1)1. When you remove the screws (A1) x 2 pcs., the record/playback head can be removed.CD-E500CD-E55/E44ø2x7mm TAPE 1How to remove the playback head (TAPE 2)(See Fig. 7-2)1. When you remove the screws (B1) x 2 pcs., the erase headcan be removed.2. When you remove the screws (B2) x 2 pcs., the record/playback head can be removed.Note:After replacing the heads and performing the azimuthadjustment, be sure to apply screwlock.How to remove the pinch roller (TAPE 1,2)(See Fig. 7-3)1. When you remove the screw (C1) x 1 pc., the pinch rollercan be removed.Note:When installing the pinch roller, pay attention to the springmounting position.How to remove the motor (See Fig. 7-4)1. Remove the belt.2. Remove the screws (D1) x 4 pcs., to remove the motorbracket.3. Remove the screws (D2) x 3 pcs., to remove the motor.(B1)x2ø2x8mmRecord/Playback Head(B2)x1ø2x7mmErase HeadRecord/Playback HeadFigure 7-1(B2)x1ø2x3mmFigure 7-2TAPE 1 TAPE 2TAPE 2How to remove the belt (TAPE 1)(See Fig. 7-5)1. Remove the main belt (F1) x 1 pc., from the motor side.How to remove the belt (TAPE 2)(See Fig. 7-5)1. Remove the main belt (G1) x 1 pc., from the motor side.2. Remove the FF/REW belt (G2) x 1 pc.Pinch Roller(C1)x1Figure 7-3MotorPinch RollerPawl(D1)x2ø2x4mmMotorTAPE 2MainBelt(G1)x1TAPE 2Main Belt(G1)x1REW/FFClutch Ass'yTAPE 1Main Belt(F1)x1MotorTAPE 1(D1)x2ø2x4mmMotorBracket(D1)x3Special ScrewMotorBracketREW/FFBelt(G2)x1MainBelt(F1)x1MotorFigure 7-5– 7 –Figure 7-4