Breathing life into your environment - Ferrob

Standard Assessment Procedure – Appendix Q MVHR Product Data 15/04/2011Table Q3 – Systems with flexible ductwork onlyExhaust terminalconfigurationKitchen +1 additional wetroomFanspeedsettingSpecificfanpower(W/l/s)Heatexchangeefficiency(%)Energy SavingTrust Best PracticePerformanceCompliantN/A N/A N/A N/AThese figures are entered into either:(a) In the case of SAP software amended to SAP 2005 version 9.81 allowing directentry of MVHR data, the SAP software, or(b) In the case of SAP software amended to SAP 2005 version 9.81 not allowingdirect entry of MVHR data, the SAP Q MVHR Calculation Spreadsheet v9.81 andthe results from the spreadsheet into the Special Features part of the SAP 9.81software, or(c) In the case of SAP software to SAP 2005 version 9.80 , the SAP Q MVHRCalculation Spreadsheet v9.80 and the results from the spreadsheet into theSpecial Features part of the SAP 9.80 software. They must NOT be entereddirectly into SAP 2005 version 9.80 softwareResults for Approved Document F (at maximum flow rate condition)Table Q4Exhaust terminalconfigurationKitchen +1 additional wet roomKitchen +2 additional wet roomsKitchen +3 additional wet roomsKitchen +4 additional wet roomsKitchen +5 additional wet roomsFan speedsetting100%Variable100%Variable100%Variable100%Variable100%VariableTotal exhaustflow rate(l/s)Total supplyflow rate(l/s)15.0 15.021.0 21.027.0 27.033.0 33.039.0 39.0CommentsOnly figures from Table Q2 or Table Q3, not both, should be used with the SAP QCalculation Spreadsheet for this technology type.Table Q4 results are only applicable for Approved Document F requirements.3 of 3