SERVICE MANUAL - BVT Partners OÜ

(b) SRF seriesRemote controllerOperation sectionFAN SPEED buttonEach time the button is pressed, thedisplay is switched over in turn.HI POWER/ECONO buttonThis button changes the HIGH POWER/ECONOMY mode.TEMPERATURE buttonThese buttons set the indoor temperature.(These buttons are used for setting thecurrent time and timer function as well.)ON TIMER buttonThis button selects ON TIMER operation.SLEEP buttonThis button selects SLEEP operation.CLEAN switchThis switch selects the CLEAN mode.CANCEL buttonThis button cancels the ON timer, OFFtimer, and SLEEP operation.Unit display sectionUnit ON/OFF buttonThis button can be used for turning on/off the unit when remotecontroller is not available.HI POWER Light (green)Illuminates during HIGH POWER operation.AIR SELECTION buttonUse this button to switch between the combination of upper andlower air outlets and upper air outlet.AIR OUTLET SELECTION light (green)Illuminates during upper air outlet operation.Remote controller signal receiver• The above illustration shows all controls, but in practiceonly the relevant parts are shown.'11 • SCM-SM-110OPERATION MODE select buttonEach time the button pressed, thedisplay is switched over in turn.ON/OFF (luminous) buttonPress to start operation, press again tostop.AIR FLOW (UP/DOWN) buttonThis button changes the air flow (up/down)direction.OFF TIMER buttonThis button selects OFF TIMER operation.ACL switchThis switch is for resetting microcomputerand setting time.RUN (HOT KEEP) light (green)• Illuminates during operation.• Blinks when airflow stops due to the ‘HOTKEEP’ and ‘CLEAN operation’.1.5 sec.ONHOT KEEPOFF0.5 sec.3 sec.ONCLEAN operationOFF1 sec.TIMER light (yellow)Illuminates during TIMER operation.ECONO light (green)Illuminates during ECONOMY operation.- -