Wheel of Fortune Pusher

More documents

Recommendations

Info

Stepper Motor& Fan AssyLED Lighting PCBWheel PerspexLED Controller& Stepper DriveCardTopSign Glitter CoatHousingLED Lighting PCB920847 Wheel Of Fortune 10
Installation & Setup3.1 Installationi. Remove the machine from the shipping crate and check that it is complete.Any special instructions and the entry keys are attached to the outer surface ofthe machine. Ensure that all transit packing is removed from outside and insidethe machine. Close and lock all doors and panels.ii.iii.iv.The machine must be installed for use on a stable, level surface. It must not beexposed to extremes of temperature or high humidity. Ensure that the mainselectrical supply is grounded and complies with the specification shown on theIdentification Label (normally located on the side of the machine). Ensure theswitch on the electrical socket is set to "ON". Connect to the mains electricalsupply using a readily accessible disconnect device, and switch on the supply,starting the machine. The power switch is located in the payout level of themachine, (see page 19)Check that all lights are working and that the pusher box is moving smoothly.When the machine appears to be functioning correctly, set up the playfields asfollows.Check that the skill arm is working correctly (see page 7, Game Play)3.2 Setting-Up the Playfield with CoinsThe following set-up procedure is recommended before the machine is played:-i. To "float-up" the play area, turn the machine on, open the glass access doorand spread approximately 720 coins evenly over the Playfield.ii. To settle the machine ready for play, feed approximately another 720 coinsevenly onto the playfield through the Coin Entry.iii. Open the Payout door and fill the Ticket Dispenser.3.3 Pre-Operation Checksi. Visually check that the playfield is correctly set up with Coins.ii. Open the Payout Door and visually check the and Ticket Dispenser is full.iii. Set the Sound Volume to the desired level (Figures 3).iv. Feed several Coins into the Coin Slot and visually check that the Coins fallonto the Playfield correctly.v. Check that the Coin Entry sound is triggered each time a Coin is entered.vi. Check the operation of the skill stop arm by pressing the button to stop thearm.CAUTION:DO NOT FILL THE COUNTHOPPER WITH COINS AS THEMACHINE WILL PAYOUTINCORRECTLY920847 Wheel Of Fortune 11
Page 2 and 3: 1 PLAYER WHEEL OF FORTUNEOPERATOR
Page 4 and 5: 1. IT IS ESSENTIAL THAT ONLY SUITAB
Page 6 and 7: 2.0 GAME PLAY & DESCRIPTIONMarquee
Page 8 and 9: Marquee AssemblySkill Stop ButtonCo
Page 12 and 13: 4.0 SecurityThe machine uses three
Page 14 and 15: 5.0 Programmer & Dipswitch Settings
Page 16 and 17: 5.3 - Dipswitch SW1DS Default Setti
Page 18 and 19: 7.0. Routine MaintenanceDaily Inspe
Page 20 and 21: .Fluorescent Lamp Lighting & Compon
Page 22 and 23: e.Pin Perspex RemovalRemove Glass p
Page 24 and 25: g.Payout LevelAt the very bottom of
Page 26 and 27: 8920847 WHEEL OF FORTUNE 26
Page 28 and 29: 9.0. PARTS LISTSPart Code Descripti
Page 34: Part Code Description No Off9.0. PA

Wheel of Fortune Pusher

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?