Cellcorder CRT-400 Quick Start Instructions - Alber

More documents

Recommendations

Info

Connecting the Resistance LeadsThese figures show connectionsfor dual post cells.Take two readings.Read with the intercell leads connectedfrom terminal posts A to C.These figures show connectionsfor triple post cells.Take three readings.Read with the intercell leads connectedfrom terminal posts A to D.Then read with the intercell leads connectedfrom terminal posts B to D.REDReading 1REDREDRED/BLACKBLACKRED/BLACKBLACKReading 1RED/BLACKBLACKThen read with the intercell leadsconnnected from terminal posts B to E.Reading 2REDReading 2Take two readings.Read with the intercell leads connectedfrom terminal posts A to C.Then read with the intercell leadsconnected from terminal posts B to D.RED/BLACKBLACKRED/BLACKREDBLACKThen read with the intercell leadsconnnected from terminal posts C to F.REDREDReading 3Reading 1RED/BLACKBLACKReading 2RED/BLACKBLACK
Transferring Specific Gravityand Temperature ReadingsSaving the Readings1. On the CRT-400, select a cell data file totransfer Specific Gravity and Temperaturereadings into. This can be readings that alreadyexist in memory or you can open a previouslysaved set of readings from the USB flash drive.2. From the Main Menu, select Test Mode/F1.3. From the Test Mode menu, select F3-S.G./Temp.Saving New Data Readings to theUSB Flash Drive1. Make sure the Cellcorder has been chargedproperly.2. The USB flash drive may be placed into theleft side USB port on the Cellcorder before orafter the Cellcorder is powered on.3. Follow the prompts on the Cellcorder’s LCDaccordingly.4. When prompted to save readings to USBflash drive, select Yes/F1.4. From the SG/Temp screen, select Import bypressing F2.5. On the Data Module, select a channel (A-H)of data to transfer.5. Follow the prompts and enter the file nameand select Save/F2.6. If the file already exists, a Warningdisplays, asking for overwrite confirmation.Press F1 to overwrite the file or F2 to entera new file name.7. The USB flash drive has now stored thenew data.Note: Do not remove the USB flash drivewhile accessing data, writing to a file, readinginformation, etc.6. Align the Data Module and CRT-400 IR port.7. On the CRT-400 press F2 for Continue.8. When transfer is done, the S.G./Temp. valuefrom Cell 1 appears.WarningNever leave the USB flash drive pluggedinto the Cellcorder when performing tests orwhile the Cellcorder is connected to abattery for testing.Readings cleared from Cellcordertemporary storage cannot be retrievedunless they have been saved to the USBflash drive or PC.9. Select Import/F2 to save the file to theUSB flash drive.
Page 1 and 2: CRT-400 Cell Resistance TesterPower
Page 3: CRT-400 Cell Resistance TesterThe C
Page 7 and 8: Files Used by the CRT-400 Cellcorde
Page 9 and 10: CRT-400 Cell Resistance TesterViewi
Page 11 and 12: Trending a Parameter Over TimeTrend

Cellcorder CRT-400 Quick Start Instructions - Alber

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?