Vector 990 Owner's Manual - Beltronics

kkkQ-START (Quick-Start Mode)Unit will bypass the power up test sequence and willdisplay the last selected traveling mode:“Au t o Sc a n ”(factory default) “Hi g h w a y ”, “Cit y X” or “Cit y ALL”.Q-Start is recommended when you are comfortablewith the detector and do not require a rundown ofsample messages. Unit is ready for operation and willdisplay Radar, Laser and SWS messages whensignals are detected.TECH MODE (Displays Frequency Received)Presents audio and text messages followed by thedisplay of the ACTUAL frequency of the receivedradar bandwidth and Laser. Unit is ready foroperation and will display Radar, Laser and SWS messages – including actual frequencies – whensignals are detected.Sample alerts while operating in Tech Mode:Laser Alert: “LASER 900NM”X Band Alert: “X BAND” followed by “10.525”K Band Alert: “K BAND” followed by “24.150”Ka Band Alert: “Ka BAND” followed by anyfrequency between 33.4 – 36.0 GHz.V-METER (Voltage Meter Mode)Presents a continuous, digital readout of yourvehicle’s battery voltage (10.5 volt to 15.5 volt range).If voltage rises above 15.5, the display will flash“HI VOLT” until the problem with your vehicle iscorrected. If voltage falls below 10.5 volts, displaywill flash “LOW VOLT” until the problem with yourvehicle is corrected.6Note: during continuous readout of your vehicle’s battery voltage, you’llnotice the mode of operation you’re traveling will be illuminated in theleft hand corner of the display in abbreviated form:Autoscan: As Highway: H City X: Cx City ALL: CA