Interpreting teqc's qc Mode Output Section 21. - Inpe

only MP1 (code) slip occurred, but was not integral number of milliseconds; detection is turned offwith -mp option2only MP2 (code) slip occurred, but was not integral number of milliseconds; detection is turned offwith -mp option-for qc full, satellite was above elevation mask, but no data was apparently recorded by the receiver;for qc-lite (no ephemeris information), the data gap must also be less than the maximum specified(see argument of -gap_mx in minutes)+(qc full only) satellite was below elevation mask and a complete set of phase and code data wascollected^(qc full only) satellite was below elevation mask and a partial set of phase and code data wascollected.phase and/or code data for SV is L1 and C/A only & A/S is off; if qc full, satellite was above elevationmask:phase and/or code data for SV is L1 and P1 only & A/S is off; if qc full, satellite was above elevationmask~phase and/or code data for SV is L1, C/A, L2, P2 & A/S is off; if qc full, satellite was above elevationmask*phase and/or code data for SV is L1, P1, L2, P2 & A/S is off; if qc full, satellite was above elevationmask,phase and/or code data for SV is L1 and C/A only & A/S is on; if qc full, satellite was above elevationmask;phase and/or code data for SV is L1 and P1 only & A/S is on; if qc full, satellite was above elevationmasko