MAXI SKY 1000 Â® CEILING LIFT SYSTEM

More documents

Recommendations

Info

$E:\Publications\User Manuals\PAC\Airtech\621900_03(UK).vp$

MAINTENANCE INSPECTION CHECKLISTMAINTENANCE INSPECTION CHECKLISTTO BE INSPECTED BY USERITEM INITIALLY BEFOREEVERYUSELIFT DEVICEEVERY2MONTHSEVERY4MONTHSInspect for missing hardware or broken panel. X X XInspect strap for wear. X XRecharging batteries.Make that rail end stoppers are in placeInspect the spreader bar on the strap of the liftfor damage or cracks.Inspect wheels in rail for damage, rust orcracks. Replace if damaged.Clean the rail and the Clip on charging stationcontacts.Overall inspection by authorized personnel.SLING AND HARDWARECheck all sling attachments for sign of wear.Inspect sling material for wear or deterioration.Inspect sling straps for wear.Inspect for any defects or loose threads in the"stitched areas".Cleaning sling as indicated on the tag.Verify emergency stop cordVerify emergency lowering device.When necessaryXXXXXXXXXEVERYYEARXXXEVERY 2YEARSMAINTENANCE BY A CERTIFIED TECHNICIANReplace strapInspect the welding aspect on the frame todetect cracksInspect sprockets for wear.Inspect connecting joints for proper attachmentVerify the emergency brake on the drum isturning freely.Verify emergency devices for good functioning.Load test with the SWL (maximum workingcapacity)Rail end stoppers inspectionXXXXXXXXMaintenance inspection points are suggested by the manufacturer, however in certain cases,some inspections should be done on a more frequent basis. By continuing to use the liftwithout replacing the listed parts in this maintenance inspection checklist, caregiver andpatient safety is greatly compromised.MAXI SKY 1000 Operating Manual 20
TROUBLESHOOTINGTROUBLESHOOTINGDO NOT attempt to open the MAXI SKY 1000 lift. Only a certified technician isauthorized to open the MAXI SKY 1000 lift.Alterations made to the MAXI SKY 1000 by someone other than a certified technicianmay cause serious injury.PROBLEMSThe red light « Service » is on andflashing.The red light is solid.The unit starts and stops repetitively.The lift emits a "beep" during utilisation.The unit may stop lifting but can stilllower it.Charge indicator on the lift (yellow) doesnot light up when the lift is on thecharger.When returning to charge, the lift passesthe Clip on charging station or takes thewrong direction.Batteries are always dead after a fewtransfers (3 to 5).The light on the charger shows a solidyellow yet the lift will only do one or twotransfers.The light on the charger shows yellowyet the lift will only work when there is noone on the lift. When you attempt totransfer someone, the lift stops.The lift does not work when you pressthe buttons on the hand control.The charging light on the lift remainsflashing yellow and does not turn yellowTO CHECKContact your supplier or your local representative to do themaintenance.The lift is under overheat protection. Wait between 10 and30 minutes until the red light turns off and press on the UPbutton to lift again.If the load is over the safe working load, the unit will notwork due to an overload protection on the motor.Batteries are low. Return the lift to the clip on chargingstation.Is the clip on charging station is plugged into a standardoutlet? If so, does the outlet have power? Clip on chargingstation indicator green light confirms the functionality of thecharger.Clean the contact blades of the charging station with milddetergent. Turn on the lift and pass the lift through thecharging station once manually, then retry the automaticreturn to charger.Verify the functioning of the lift charger and the contactfingers on the clip on charging station.Replace batteries by new ones. The life of the current oneis probably over. It is important to always change bothbatteries at the same time. (Contact your local dealer oryour representative to have batteries replaced)Contact your local dealer or representative to havebatteries replaced.Contact your local dealer or representative to havebatteries replaced.Is the charger light is on? The lift must be moved awayfrom the charger in order to operate. .Is the emergency stop activated? Gently pull the red cordonce until the green light is on.Are the buttons on the lift functioning? If so, the problemmay come from the hand control connection. If not, checkthe charge on the lift.Is the hand control properly plugged into the lift? The handcontrol may be slightly pulled out its socket yet appear asthough it is plugged in. Pull out the plastic cover to checkthe connection.Slide the lift over the clip on charging station. Is the yellowlight on?If, after testing all of the above, the lift will not operate,contact your local dealer or your representative.If available, try another integrated clip on charging stationfrom another lift or a spare one; plug it into the rail andMAXI SKY 1000 Operating Manual 21
Page 1 and 2: OPERATING MANUALMAXI SKY 1000 ®CEI
Page 3 and 4: Arjo designs and manufactures quali
Page 5 and 6: INTRODUCTIONHow to use this ManualD
Page 7 and 8: SAFETY INSTRUCTIONS AND WARNINGSDO
Page 9 and 10: DESCRIPTIONParts descriptionCharger
Page 11 and 12: OPERATION12. When the lift is no lo
Page 13 and 14: MAINTENANCECharging the batteriesDO
Page 15 and 16: MAINTENANCEALWAYS CARRY OUT THEDAIL
Page 17 and 18: MAINTENANCETake note of inspection
Page 19: ERGOFIT SLINGSBariatric Sling (TOB)
Page 23 and 24: ACCESSORIESACCESSORIESCHARGER AND C
Page 25 and 26: LOGBOOKService Type Pre-delivery Pe
Page 27: MAXI SKY 1000 Operating Manual 27

MAXI SKY 1000 Â® CEILING LIFT SYSTEM

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?