PIERBURG

PIERBURGServiceinformationsSafety shut-offfor electric fuel pumpsWhen installing an electric fuel pump instead of amechanic pump, we recommend for safety reasonsalways to install a safety shut-off device.The safety shut-off device shuts down the fuel pumpeven when the ignition is switched on if the enginedoes not run.Pierburg provides a safety shut-off device as aninstallation kit.Order no.: 4.05288.00si 0016/A GBMSI-PG 10.02Scope of delivery1 switch relay with counter connector, mountedconnection lines and safety holder with 2A fuse.1 ground cable for fuel pump2 fitting bolts6 different cable connectors1 cable binder1 installation instruction sheetFor fitting, connection and function test,see à overleaf.Registration number 4/4 00-162.1 GBFor changes with regard to part matching and spares,refer to the catalogue currently in effect.MSI Motor Service International GmbH • Hamburger Straße 15 • D-41540 Dormagen • Phone +49 (21 33) 267-100 • Fax +49 (21 33) 267-111www.msi-motor-service.com

Installation and connectionOnly a qualified person may carry out this work.• Switch of ignition and disconnect the battery.• Fit relay with mating connector in a locationprotected against heat and spray water.• Connect safety shut-off device as shown inthe wiring diagram (see à Fig.). Refer towiring diagram of the vehicle if necessary.• Route cables so that they do not come intocontact with hot parts of the engine.Pumps with a higher rating must befused according to their current consumption (up to max. 16A).See à Fuel pump catalogue.Wiring diagram1 Terminal 15 (12V) 7 brown2 Ignition coil 8 brown3 Distributor 9 Relay4 red 10 Fuseholder with 2A fuse5 black 11 electric fuel pump6 greenFunction testPrecondition: Fuel lines and battery connected.• Switch on ignitionDepending on the position of the distributor,the fuel pump may run for about 2 seconds.• Start engine.The fuel pump must run.If the engine does not start, the pump willstop after about 2 seconds.• Switch off the ignition with the engine running.The fuel pump stops immediately.• In the event of faults, repeat connection asshown in the wiring diagram.Assignments of relay socketSocket Cable Relay terminalNo. Colour No.2 red 304 black 31b5 brown 316 red 158 green 87Lock cable from below.A jumper is present between the redcables.