Grandstream Handytone 486 User Manual (PDF) - VoIPon Solutions

More documents

Recommendations

Info

HandyTone-486 User ManualGrandstream Networks, Inc.and Provisioning:fm.grandstream.com/gsFirmware Server Path:fm.grandstream.com/gsConfig Server Path:Firmware File Prefix:Config File Prefix:Firmware File Postfix:Config File Postfix:Automatic Upgrade:NoYes, check for upgrade every10080 minutes (default 7 days)Always Check for New FirmwareCheck New Firmware only when F/W pre/suffix changesAlways Skip the Firmware CheckFirmware Key:Authenticate Conf File:No(in Hexadecimal Representation)Yes (cfg file would be authenticated before acceptance if set to Yes)Lock keypad update:NoAllow conf SIP Accountin Basic Settings: No YesOverride MTU Size: 0Volume Amplification: TX0dB defaultYes (configuration update via keypad is disabled if set to Yes)RXCall Progress Tones: Frequency 1(Hz)0dB defaultFrequency 2(Hz)ON (x10ms)(C1;C2;C3)Dial Tone 350 440 0 0Recall Dial Tone 350 440 10 10Message Waiting 350 440 10 10Confirmation 350 440 10 10Audible Ringing 440 480 200 400Busy Tone 480 620 50 50Reorder Tone 480 620 25 25OFF (x10ms)(C1;C2;C3)ReceiverOffhook Tone1400 2600 10 10Update Cancel RebootAll Rights Reserved Grandstream Networks, Inc. 200528VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030
HandyTone-486 User ManualGrandstream Networks, Inc.Admin PasswordSIP ServerOutbound ProxySIP User IDAuthenticate IDAuthenticationPasswordNameHome NPAPreferred VocoderG723 Rate:iLBC frame size:Administrator password. Only administrator can configure the “AdvancedSettings” page. Password field is purposely left blank for security reason afteruser clicks UPDATE button. This field is case sensitive and the maximumpassword length is 25 characters.IP address or Domain name provided by VoIP service providerIP address or Domain name of Outbound Proxy, or Media Gateway, or SessionBorder Controller. Used by ATA for firewall or NAT penetration in differentnetwork environment. If symmetric NAT is detected, STUN will not work andONLY outbound proxy will provide solution for it.User account information, provided by VoIP service provider (ITSP), usuallyhas the form of digit similar to phone number or actually a phone number.ID used for authentication, usually same as SIP user ID, but could be differentand decided by ITSP.Account information, password for ATA to register to (SIP) servers of ITSP.SIP service subscriber’s name which will be used for Caller ID display.Local area code for North American Dial Plan.The HandyTone ATA supports 6 different codec types including G.711 A/Ulaw,G.723.1, G.726, G.729A/B, iLBC.A user can configure Codecs in a preference list that will be included with thesame preference order in SDP message.Encoding rate for G723 codec. By default, 6.3kbps rate is set.iLBC packet frame size. Default is 20ms. For Asterisk PBX, 30ms might berequired.iLBC payload type: Payload type for iLBC. Default value is 97. The valid range is between 96 and127.Silence Suppression This enables/disables the silence suppression/VAD feature of G723. If set to“Yes”, when a silence is detected, small quantity of VAD packets (instead ofaudio packets) will be sent during this period. If set to “No”, this feature isdisabled.29VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030
Page 1: User ManualHandyTone-486Analog Tele
Page 4 and 5: HandyTone-486 User ManualGrandstrea
Page 6: HandyTone-486 User ManualGrandstrea

Grandstream Handytone 486 User Manual (PDF) - VoIPon Solutions

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?