HP Series Operating Manual - Jands

Installation 6-96.3 Mounting the dimmer to the bracketDimmers are attached to the pre-mounted brackets as follows:1 Remove the dimmer’s right-hand front panel (eight screws).2 Hang the top edge of the dimmer on the two bracket tabs. These support theweight of the dimmer while allowing the bottom of the dimmer to pivot away fromthe bracket.3 Feed any cables (mains supply, output or control) into the rear of the dimmer andterminate them as necessary. This may only be performed by a licencedelectrician.4 Latch the dimmer onto the bracket by lifting the dimmer a few millimetres andallowing the bottom two bracket tabs to engage.5 Lock the dimmer in place with one M4 screw at the bottom right inside corner.6 Re-attach the front panel.2TOPJANDSHP12WMDANGERHIGH VOLTAGEOUTPUTS4MAINS1JANDSEARTHDMX 356Revision 2 - 20 March, 1997 HP SERIES DIMMER OPERATING MANUAL