DRAIN KIT INSTALLATION INSTRUCTIONS - Amana PTAC

Installation for Indoor UseThe components of the wall sleeve drain kit for indoor use are shown in figure below. These components must beinstalled prior to the installation of the wall sleeve.MTG.SCREWS (2)DRAINGASKETWALLSLEEVEBOTTOMDRAINFITTINGPLATEDetail A1. Locate an area on the wall sleeve that will be inside theroom when the sleeve is installed. If a subbase isinstalled, locate the kit a minimum of 3 1/2” from thefront flange of the wall sleeve. This clearance willprovide adequate clearance for the subbase.2. Cutout the template shown to the right. Using thistemplate, locate and drill the drain kit holes as close tothe outside wall as possible.3. Using detail A (above) as a guide, assemble the draingasket, drain fitting plate, and indoor drain fitting together.Install the assembly into the drilled holes andsecure using the two indoor mounting screws provided.The screws must be inserted INSIDE the wallsleeve.and TOP driven down into the drain fitting plate.Ensure drain tube is not restricted. Cover the twoscrew heads with a good quality outdoor caulking (notsupplied) for additional corrosion protection.NOTE: If the drain fitting is not connected to an indoordrainage system immediately after the wall sleeve isinstalled; plug the hole with cork (not included) toprevent indoor water damage in case it rains.4. Install a 1/2” ID tube or hose (not included) on the drainfitting and interconnect it to the drain system inside ofthe building. Ensure that there are no kinks or traps intube or hose. Kinks or traps can cause improperdrainage.5. Install the two drain blank-off plates and outdoor draingaskets on the outdoor portion of the wall sleeve asshown in the figure above. These components can beinstalled after the sleeve is secured in the wall openingjust prior to the installation of the condenser grille andchassis..187" DIA.MTG. HOLES(2).687" .687"INSIDE EDGE OFFRONT SLEEVE FLANGE.500" DIA.Template3.5" Min.for PTSBclearance(not toscale)Due to policy of continual productimprovement, the right is reserved tochange specifications and designwithout notice.C L ofMTG.HOLESMIN.DIM.2 Made in USA