Assembly instructions - KLARO GmbH

More documents

Recommendations

Info

Assembly instructions for KLARO retrofit kitsFigure 19: Piping for the aeration unit with 3 discsFigure 20: Piping for the aeration unit with 4 discsAfter the aeration unit has been placed in the tank, the supplied concrete weight is threadedvia the vertical downpipe for vertical fixation and lowered to the bottom.Figure 21: Tank diameter of 2 mFigure 22: Tank diameter of 2.5 mImportant information about the anchor bolt assembly:1. Make a borehole.2. Clean the borehole.3. Drive the bolt into concrete up until the seat depthmark.4. After the nut has been tightened, screw on the pipeclamp.12 KLARO GmbH
Assembly instructions for KLARO retrofit kitsTraverse2x Stainless steel pipe clamp1x Threaded rod1x Stainless steel pipe clamp1x Hexagonal bolt1x Nut2x PE pipe clampfitted into each otherDN 50DN 70DN 50DN 701x PE pipe clamp1x Stainless steel pipe clamp1x Hexagonal bolt1x PE pipe clamp1x Stainless steel pipe clamp1x Threaded rod2x Stainless steel pipe clamp1x Threaded rodFigure 23: Attaching the clearwater lift (DN50 or DN70) to the stainless steel downpipeFasten the lift by means ofthe drilling screw1x Stainless steel pipeclamp1x Anchor boltFigure 24: Attaching the inlet lift (DN50 3 pipeclamps, DN70 4 pipe clamps)Figure 25: Attaching the excess sludge liftKLARO GmbH 13
Page 1 and 2: Assembly instructionsfor KLARO retr
Page 3 and 4: Assembly instructions for KLARO ret
Page 11: Assembly instructions for KLARO ret

Assembly instructions - KLARO GmbH

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?