Operating Manual Electronic Column Scale M20610 - Dencor

- The mains adapter is not waterproof. Therefore make sure NOT to use the scale where watercan penetrate.- In case the mains adapter became wet or show visible damages the scale can no longer beoperated by using this mains adapter. In this case please contact your local dealer or servicepartner.WeighingTo take the weight- Press key ON to start the scale. `8888´will appear on the display which is an automaticfunction test and zero setting. When `0.0´appears you are in the kg weighing mode. In additiondisplay will show the symbol `o´ to confirm stability of the zero setting.- The scale may now be used.- Step on the platform and stand still.- After display is showing your weight and symbol `o´ appeared the most accurate result hasbeen reached.- To turn off the scale press key OFF for minimum 3 seconds. This is essential if scale is usedon batteries. Using the scale on mains it may remain permanently switched on or can be shutoff manually by pressing key.Change unit functionYou may select the weight unit between kg and lb mode. Coming from the factory the scale isswitched to kg mode. To change into lb mode press UNIT/WEIGHT key.Caution- Please check weighing mode after switching to get proper result.Set zeroYou may set any displayed weighing result back to zero `0.0´by pressing the ZERO key. Theadvantage is to weigh shoes or dress separately.- Place objects on the scale.- Press ZERO key.- Unload the scale.- The weight displayed before is showing a negative value and will be deducted automaticallyduring the next weighing procedure.- The negative value will not be stored.050100-Rev001-M20610 4