Operating Manual Electronic Column Scale M20610 - Dencor

HOLD functionBy using the HOLD function the identified weight might be stored and is shown on the display even ifyou stepped already off the scale. The advantage is to take care of the patient first and then take noteof the weight.- Press HOLD/BMI key while scale is under load.- The display shows a blinking arrow symbol next to the HOLD symbol.- Once the scale is loaded with more than 3 kg the blinking stops.- The weight displayed will now also show after unloading of the platform.- To deactivate the Hold function press again HOLD/BMI key.Cleaning and MaintenanceCleaningBefore cleaning make sure the scale has been disconnected from the socket.For cleaning just use a damp cloth or common disinfection fluids.Do not use any aggressive cleaning fluids.Make sure no water or cleaning fluids is penetrating the scale.Your ADE scale is equipped with a mains adapter and rechargeable batteries.If the display shows the symbol `Low´ the power pack needs to be recharged by using the adapter.Safety CheckDo NOT use the scale• If the mains adapter shows visible damages.• if the mains adapter is not working properly any more• After long storage in humid placesPlease contact your dealer or service partner in those cases.Storage and TransportPlease keep all original parts and pieces for an eventual sending back of the scalein order to avoid any possible damage during transport which automatically leads to non warranty.Disconnect all cables before transport and avoid unnecessary damages.Warranty – LiabilityADE will repair or replace this product within a period of 2 years from date of delivery applying todefects occurred due to poor material or workmanship (presentation of invoice is necessary). Allmoveable parts – batteries, cables, mains units, rechargeable batteries etc. – are excluded. Warrantydoes not include natural wear, damages caused by incorrect or negligent handling, overuse orunsuitable or improper storage. The cost of transport will be borne by the customer should theequipment be located anywhere other then the customer’s premises. In the event of transportdamage, claims under warranty can be accepted subject to using the complete original packaging andthe equipment secured the way it was packed and secured originally. All the packaging shouldtherefore be retained.050100-Rev001-M20610 6