MAXxess Configuration Guide - MAXxess Systems Inc.

BLP Processors200 SeriesStandard FeaturesModel Part Weigand Barcode Inputs Outputs Fiber RS-232/485 CardNumber Number Readers/ Readers/ (or) Modem CapacityKeypads Keypads CapableBLP-201 7004-106 2 4 4 ✔ 100k*BLP-211 7004-123 2 4 4 ✔ ✔ 100k*BLP-206 7004-132 2 4 4 ✔ 100k*BLP-216 7004-136 2 4 4 ✔ ✔ 100k*General Notes: The BLP Processor controls and monitors (2) doors/readers. It comes equippedwith (4) inputs providing monitoring of (1) Door Sensor and (1) Request-to-Exit Device (REX) foreach door. It also has (1) Quad Output Module included, providing (4) Control Outputs, (1) for eachdoor and (2) spare, auxiliary outputs. The BLP is provided in a locking enclosure with a din railmounting kit and a 16VAC/20VA transformer is included for BLP power. Separately estimate a 12-volt, 7-amp/hour battery for 12-hour minimum backup operation, as well as a BUPS from theMAXxess Price List or another Power Supply of your choosing, to power auxiliary equipment suchas electric locks.Readers/Keypads: If your using Barcode Readers and Keypads, select the BLP-201 or BLP-211processors (please refer to the MAXxess Price List to select readers/keypads.) The BLP-201 andBLP-211 have separate connectors for the reader and keypad.If your using Wiegand input devices (smart card, proximity readers, magnetic-stripe, keypads, biometric,etc.,) select the BLP-206 processor (please refer to the MAXxess Price List to select readers.)The BLP-206 and BLP-216 have a single connector for a reader and keypad that is combinedin a single housing. If you are using a keypad that is not from MAXxess, make sure the keypad hasan 8-bit output so that the BLP Processor can distinguish it from the card reader (for example, 26-bitfrom the card reader and 8-bit from the keypad.)Many other Wiegand formats beyond 26-bit have been qualified by MAXxess to work with the BLP-206/216 Processors. If you are using readers and cards that are not listed in the MAXxess Price List,please contact MAXxess to insure compatibility. (Please see MAXxess Application Note No. 12 fora more complete discussion of this subject. Application Notes may be found in the Support section ofthe MAXxess website.)Fiber Optics: If your using Barcode Readers/Keypads and you require direct Fiber Optic connectivityon-board the processor, select the BLP-211. If you’re using Wiegand readers/devices and yourequire direct Fiber Optic connectivity on-board the processor, select the BLP-216.26