Mass flow meters - OPTIMASS 1000 - Forbes Marshall

More documents

Recommendations

Info

3 INSTALLATIONOPTIMASS 10003.2.3 Maximum pipework forces (end loadings)Mass flowmeters have a maximum level of force (negative or positive) that can be applied to theends of the meter. Refer to the table below for permitted forces.Maximum end loadingsS15 S25 S40 S50Flanges20°C 40 barg 25kN 38kN 48kN 99kN100 barg 17kN 19kN 15kN 20kN130°C 32 barg 18kN 28kN 35kN 72kN80 barg 12kN 12kN 7kN 8kNHygienic (all connections)130°C 10 barg 5kN 9kN 12kN 12kN• These (axial) loads have been calculated, based on 316L schedule 40 process pipework,where un-radiographed butt welds have been used in pipe joints.• The loads shown are the maximum permitted static load. If loads are cycling (betweentension and compression) these loads should be reduced. For advice, consult themanufacturer.30www.krohne.com03/2011 - 4000040304 - TD OPTIMASS 1000 R05 en
OPTIMASS 1000403/2011 - 4000040304 - TD OPTIMASS 1000 R05 enwww.krohne.com31
Page 1 and 2: OPTIMASS 1000 Technical DatasheetSe
Page 3 and 4: OPTIMASS 1000PRODUCT FEATURES 11.1
Page 5 and 6: OPTIMASS 1000PRODUCT FEATURES 11.2
Page 7 and 8: OPTIMASS 1000PRODUCT FEATURES 1Ener
Page 9 and 10: OPTIMASS 1000TECHNICAL DATA 2Temper
Page 11 and 12: OPTIMASS 1000TECHNICAL DATA 2ATEX (
Page 13 and 14: OPTIMASS 1000TECHNICAL DATA 2OPTIMA
Page 15 and 16: OPTIMASS 1000TECHNICAL DATA 22.3 Gu
Page 17 and 18: OPTIMASS 1000TECHNICAL DATA 22.4 Di
Page 19 and 20: OPTIMASS 1000TECHNICAL DATA 2ASME 1
Page 21 and 22: OPTIMASS 1000TECHNICAL DATA 22.4.2
Page 23 and 24: OPTIMASS 1000TECHNICAL DATA 2Hygien
Page 25 and 26: OPTIMASS 1000TECHNICAL DATA 22.4.3
Page 27 and 28: OPTIMASS 1000INSTALLATION 33.1 Inte
Page 29: OPTIMASS 1000INSTALLATION 3Zero cal

Mass flow meters - OPTIMASS 1000 - Forbes Marshall

Create successful ePaper yourself

Delete template?

Save as template?