Infinity - Whip Mix

More documents

Recommendations

Info

FIELD SERVICEREPLACEMENT OF HEATING PLATESREPLACEMENT PART NUMBERS100V 115V 220/230V 240VM-30 (Set of 2) 18907 33915 33916 33916 .. . .L-30Set of 2 Side Plates 27957 33918 27957 33918 .Set of 2 Rear Plates 27956 33917 27956 339171. Remove the back panel of the furnace.2. Remove the nuts which hold the heating plate wires to the power terminals and straighten the heatingplate wires (Figure 4).3. Open the furnace door and find the two ceramic sections at the front of the furnace chamber. Hold thefurnace door partially open while removing the ceramic sections. They are not readily removed when the..door is fully open. Remove the right-hand ceramic section by lifting it upward until the bottom of the section..clears the sheet metal housing. Pull the bottom of the ceramic section out, then pull it down so the upper..half clears the sheet metal housing. Remove the left-hand ceramic plate in the same way.4. Remove the floor plate, then carefully slide the two side heating plates out the front of the furnace. The tworear heating plates on Infinity L-30 may now be removed.5...Check the condition of the filler strip insulation in the space to the left and right of the ceramic frontsections. Replace if required*.6...Check the condition of the floor plate which provides insulation and serves as a spacer between the bottom..ends of the heating plates. Replace if required*.7. To install the new heating plates reverse the procedure. Push the ceramic heating plates back into place on..the rear insulating panel. When reconnecting the heating plate wires at the rear of the furnace, be sure to..replace all hardware in its original position. (Figure 4.) Tighten all connections.*Replacement Part: Floor Plate w/ Filler Strip Insulation.......Infinity M-30: PN 33980; Infinity L-30: PN3398121
Figure 4INFINITY WITH UPPER REAR PANEL REMOVEDJumperHeating Plate WirePower TerminalRear Insulating PanelThermocoupleThermocouple ClampCeramic InsulatingBushingHeater (Power) LeadsInsulating FillerINFINITY M-30 (ALL VOLTAGES)JumperRear Insulating PanelHeating Plate WirePower TerminalThermocoupleThermocouple ClampCeramic InsulatingBushingHeater (Power) LeadsInsulating FillerINFINITY L-30 100, 115 VOLTHeating Plate WirePower TerminalRear Insulating PanelThermocoupleThermocouple ClampCeramic InsulatingBushingHeater (Power) LeadsInsulating FillerINFINITY L-30 220/230, 240 VOLT22
Page 5 and 6: KEY PARTS IDENTIFICATION AND EXPLAN
Page 7 and 8: key parts identification and explan
Page 9 and 10: installationto turn the “beep”
Page 11 and 12: operationprogram and operate - TWO
Page 13 and 14: operationprogram and operate - four
Page 15 and 16: OPERATIONedit while a program is ru
Page 17 and 18: OPERATIONSample three STAGE program
Page 19 and 20: ERROR CODESerrorcode DESCRIPTION PR
Page 21: SERVICE6. When the tablet begins to
Page 25 and 26: Figure 5INFINITY WITH FRONT PANEL /
Page 27 and 28: FIELD SERVICEREPLACEMENT OF THE TRI
Page 29 and 30: SPARE PARTS LISTPARTS FOR INFINITY
Page 31 and 32: PROGRAM CARD FORMSProgram #Metal(s)

Infinity - Whip Mix

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?