Electronic Pressure Switch EDS 8000 - HYDAC USA

More documents

Recommendations

Info

User manual EDS 8000 US Page 107.2 Extended functionsStatus 09.09.2009 HYDAC ELECTRONIC GMBH Part No. 669820
User manual EDS 8000 US Page 118 Error messageIf an error is detected, a corresponding error message appears that must beacknowledged by pressing any key.Possible error messages:E.10 A data error was detected in the saved settings. This could be due to strongelectromagnetic interference or a component fault.Action: Press E and confirm "RES" by pressing "Yes". The factory settings will berestored for all adjustable parameters and all minimum and maximum valueswill be deleted. Enter the data again from the beginning.E.12 An error was detected in the saved calibration data. This could be due tostrong electromagnetic interference or a component fault.Action:Disconnect then reconnect the supply voltage to the instrument. If the errorpersists, the instrument must be returned to the factory for recalibration orrepair.E.21 A communication error was detected within the instrument. This could be dueto strong electromagnetic interference or a component fault.Solution: Press E . If the error persists, disconnect then reconnect the supply voltageto the instrument. If the error still persists, please contact our servicedepartment.9 Pin assignmentVersion with 2 switch outputs:Male 4 pole, M12x1250 mAEDS 8446-2 84x6-2250 mAStatus 09.09.2009 HYDAC ELECTRONIC GMBH Part No. 669820
Page 4 and 5: User manual EDS 8000 US Page 44 Con
Page 6 and 7: User manual EDS 8000 US Page 6NOTE:
Page 8 and 9: User manual EDS 8000 US Page 8Examp
Page 12 and 13: User manual EDS 8000 US Page 1210 T
Page 14 and 15: User manual EDS 8000 US Page 1412 A
Page 16: User manual EDS 8000 US Page 16HYDA

Electronic Pressure Switch EDS 8000 - HYDAC USA

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?