high pressure pump series 21 - BIBUS
high pressure pump series 21 - BIBUS
high pressure pump series 21 - BIBUS
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Compressed AirThe Yamada 2:1 <strong>high</strong> <strong>pressure</strong> <strong>pump</strong> was specifically designedfor applications where 100 PSI maximum <strong>pump</strong> operating<strong>pressure</strong> is not enough to overcome system requirements.The flow rate is roughly half of the same size <strong>pump</strong>output, though a discharge <strong>pressure</strong> of 200 PSI can beachieved with only 100 PSI air inlet <strong>pressure</strong> supplied. The2:1 discharge <strong>pressure</strong> ratio is achieved by utilizing twice thesurface area (driving both diaphragms) to double the output.Key Advantages:Blind SeatDischarge at 2 timescompressed airBall ChecksPumpedMediaNo elaborate bypass requiredNo relief valves requiredNo complicated controls requiredGreat <strong>pressure</strong> retention (ability to hold<strong>pressure</strong>)3/4” through 3” port sizes available316 Stainless Steel, Cast Iron, and Aluminumwetted materialsEPDM, Neoprene, Buna N, Viton® fluoroelastomer,Santoprene®, and Hytrel® elastomersCapacities from 1 to 100 GPMDischarge <strong>pressure</strong> to 200PSICan handle solids as large as
Performance Data:Performance curves are based on normal temperature (70°F), freshwater. The discharge volume and discharge head vary according to viscosity,specific gravity, etc. of the material to be transferred.Note: 2:1 <strong>high</strong> <strong>pressure</strong> <strong>pump</strong>s are considered simplex <strong>pump</strong>swhich will increase pulsation during operation. ConsultYamada for proper pulsation dampener selection.Your local distributor:Nordel®, Viton®, Teflon® & Hytrel® are registered trademarks of DuPont PerformanceElastomers Santoprene® is a registered trademark of Monsanto CompanyNote: Due to Yamada’s continued commitment to product improvement, specifications may change without notice.Form# HP0309