Cavitron® SPS™ - Dentsply

6.6 Installation and Operation TablesCavitron SPS G-98A ConnectionBROWN & YELLOW WIRES24 Volts AC PowerDental Control Unit HeadConnect to terminal strip.24 Volt AC, 300 Watt Power SupplyRED TUBEScaler Water SupplyTee into RED Control Block Manifold water tube25–60 psi Water SupplyYELLOW TUBEHandpiece Selection Pilot AirUse installation tubing kit to Tee into YELLOW-REDtube on Control Block Manifold – Pilot Air..005 Restrictor Barb installed in series.Unused handpiece holder or handpiece whipposition required.ORANGE TUBEFoot Control Drive AirTee into ORANGE-BROWN tube on Control BlockManifold – Drive Air.SCALER 24 VAC POWER ACTIVATION – Yellow Tube1. Cavitron Steri-Mate ScalerHandpiece IN Holder.2. Cavitron Steri-Mate ScalerHandpiece whip RELEASED.Scaler 24 VAC Power – OFFAir–Electric switch – CIRCUIT OPEN1. >20 psi air pressure to Yellow tube. HP HolderWhisker valve sealed.2. >20 psi air pressure to Yellow tube. Handpiecewhip bleed valve sealed.1. Cavitron Steri-Mate ScalerHandpiece selected andREMOVED from Holder.2. Cavitron Steri-Mate ScalerHandpiece whip selected andPULLED FORWARD.Scaler 24 VAC Power – ONAir–Electric switch – CIRCUITCLOSED1. 2–20 psi air pressure to Yellow tube. HP HolderWhisker valve bleeds air pressure off.2. 2–20 psi air pressure to Yellow tube. Handpiecewhip bleed releases air pressure.NORMAL & BOOST ULTRASONIC SCALING POWER – Orange TubeProportional Foot Controldepressed partially.Cavitron SPS Ultrasonic scalingpower activated in NORMAL mode.Dual Air-Electric Switch, S1 CLOSES(S1 = Blue & Black Leads)2–12 psi air pressure to Orange tube.Proportional Foot Controldepressed to a lower positionor completely.Cavitron SPS Ultrasonic scalingpower will switch from NORMALmode to BOOST mode.Dual Air-Electric Switch, S1 and S2CLOSE (S1 = Blue & Black Leads,S2 = White & Black Leads)1240 – 80 psi air pressure to Orange tube.