MD100 NOTE DISPENSER - Blueprint Gaming

More documents

Recommendations

Info

• REVERSE THE ABOVE STEPS FOR INSTALLING THE DISPENSER UNIT INTO THE MACHINE.THE CABLE CONNECTOR IS ‘KEYED’ SO CAN ONLY BE FITTED THE CORRECT WAY. FORCING THE CONNECTORIN THE WRONG WAY ROUND WILL CAUSE 24v TO BE FED INCORRECTLY INTO THE MD100 CAUSING POSSIBLEDAMAGE TO THE UNIT & THE MACHINE WIRING LOOM.• ENSURING THE UNIT IS CORRECTLY PLACED ON THE 4 SECURING BOLTS TO THE REAR & THE CABLE ISSAFETY CONNECTED TO THE LEFT SIDE OF THE MACHINES.ONCE FITTED, IF THE TOP OF THE DISPENSER UNIT CAN BE ‘ROCKED’ FORWARD, THEN THE UNIT IS NOTSECURED ON THE SECURING BOLTS.NOTE : WHEN REMOVING AND RE-FITTING THE UNIT, BE CAREFUL NOT TO TRAP THE CABLES RUNNING ONTHE LEFT & BEHIND THE DISPENSER UNITSETTING THE NOTE DISPENSER POSITIONIT IS IMPORTANT TO ENSURE THE NOTE ACCEPTOR BEZEL IS SET IN THE CORRECT POSITION SO THAT THEDISPENSED NOTES EXIT THE NOTE ACCEPTOR AND MAIN CABINET DOOR AREA SMOOTHLY.FAILURE TO SET THE POSITION CORRECTLY CAN CAUSE THE DISPENSED NOTES TO BECOME JAMMED WITHINTHE MACHINE.TO SET THE DISPENSER UNIT POSITION,• CHECKING WHERE THE TOP DOOR MEETS THE NOTE ACCEPTOR BEZEL, ENSURE THERE IS NO GAPBETWEEN THE DOOR AND THE BEZEL ENTRY. EVEN A 3mm GAP CAN CAUSE THE NOTES TO BECOMEJAMMED WITHIN THE MACHINE!• USING THE HORIZONTAL & VERTICAL ADJUSTERS ON THE DISPENSER UNIT BRACKET (fig.5) SET THEPOSITION SO THAT THE NOTE ACCEPTOR BEZEL IS LINED UP CORRECTLY WITH THE TOP DOOR NOTEACCEPTOR HOLE.6
Fig.5 – MD100 position adjusters7
Page 8 and 9: Manual removal of notes from the MD

MD100 NOTE DISPENSER - Blueprint Gaming

Create successful ePaper yourself

Delete template?

Save as template?