Jeep Wrangler 4-Door - 2007-Newer Installation ... - RealTruck.com

More documents

Recommendations

Info

Remove passenger side front door sill.Lift carpet. Slit rubber grommet and pass triggerwires through grommet in floor into passengercompartment.13Posi-Tap instructions14Use Posi-Tap connectors to connect Power Steptrigger wires to like colored wires in the factorysystem as shown: Violet/White wire in loomcoming from front door, Violet/Yellow and Violet/Grey in main loom in door sill.InsertTightenStrip 3/8”Insert and15Tighten16Remove driver side door sill and pull upcarpet.Route Violet wire under carpet to driver sidedoor sill and connect to violet wire comingfrom door as shown.17www.amp-research.com 6/818IM75122 rev 03.29.11
AMP RESEARCH POWER STEP – JEEP WRANGLER (JK)Insert plug from wire harness onto motor. Sliderubber grommet on wire harness into slot of motorcover. Insert motor cover onto motor. Slide motorassembly onto drive shaft and mounting bosses ofdriving linkage assembly. Use electrical tape to coverany exposed wire from the motor.5 6Insert plastic push pin rivets in mounting holes ofmotor cover. Use pliers to ease installation.615819 20On each side of the vehicle measure from the frontedge of the door line on the pinch weld to the specified lengths below. Measure at 8” for the front LEDlamp and 45” for the rear LED Lamp.Drill a 9/32” hole through pinch weld at locationsmarked out in step 21.21Insert grommet and lamp wires through drilled hole.Affix lamp to rocker panel surface. Make sure thelamp is affi xed to a clean, fl at surface.45”8”22Using supplied butt connectors, connect the lampwires. Red to Red, Black to Black.21201923www.amp-research.com 7/824IM75122 rev 03.29.11
Page 1 and 2: INSTALLATION GUIDEAPPLICATION AMP P
Page 3 and 4: AMP RESEARCH POWER STEP - JEEP WRAN
Page 5: AMP RESEARCH POWER STEP - JEEP WRAN
Page 9: Congratulations on your purchase of

Jeep Wrangler 4-Door - 2007-Newer Installation ... - RealTruck.com

Create successful ePaper yourself

Delete template?

Save as template?