Cisco Content Services Switch Routing and Bridging Configuration ...

Configuring InterfacesChapter 1Configuring Interfaces and CircuitsTo disable BPDU guard, use the global configuration bridge bpdu-guarddisabled command:(config)# bridge bpdu-guard disabledShowing Port Fast InformationTo display whether Port Fast is enabled or disabled on all interfaces, use the showbridge port-fast command. This command is available in all modes. Thiscommand also displays whether the BPDU guard feature is enabled or disabled onthe CSS, and the state of the interfaces.Table 1-2 describes the fields in the show bridge port-fast command output.Table 1-2Field Description for the show bridge port-fast CommandFieldBPDU guard is stateon this switch.NameIfIndexTypeOperAdminPortFast StateDescriptionThe state of the BPDU guard feature on the CSS:Enabled or Disabled.The number of the module slot and interface.The interface index number.The type of interface.• fe indicates a Fast Ethernet interface.• ge indicates a Gigabit Ethernet interface.The operational state of the interface: Up or Down.The administration state: Enable or Down.Indicates whether Port Fast is enabled or disabled on theinterface.1-18Cisco Content Services Switch Routing and Bridging Configuration GuideOL-8241-02