Cisco Content Services Switch Routing and Bridging Configuration ...

Configuring InterfacesChapter 1Configuring Interfaces and CircuitsTo display bridge forwarding or bridge status for a specific VLAN in the CSS,enter the show bridge forwarding or the show bridge status command with theVLAN number. Entering the show bridge command with a VLAN numberreturns a list of available VLANs.Table 1-3 describes the fields in the show bridge forwarding command output.Table 1-3Field Descriptions for the show bridge forwarding CommandFieldVLANMAC AddressPort NumberDescriptionThe bridge interface virtual LAN numberThe MAC address for the entriesThe port number for the bridge forwarding tableTable 1-4 describes the fields in the show bridge status command output.Table 1-4Field Descriptions for the show bridge statusCommandFieldSTP StateRoot Max AgeRoot Hello TimeRoot Fwd DelayDesignated RootBridge IDPortDescriptionThe state of the Spanning-Tree Protocol: Enabled orDisabled.The timeout period, in seconds, during which the host timesout root information.The interval, in seconds, that the root bridge broadcasts itshello message to other CSSs.The delay time, in seconds, that the root bridge uses forforward delay.The bridge ID for the designated root.The bridge ID of this bridge.The port ID.1-20Cisco Content Services Switch Routing and Bridging Configuration GuideOL-8241-02