TECHNICAL MANUAL - BVT Partners OÜ

'11 • SRK-T-105(b) Wired remote controller (option parts)Interface kit (SC-BIKN-E) is required to use the wired remote controller.Wiring outletCut off the upper thin part of remote control lower case with a nipper or knife,Exposed mountingand grind burrs with a file etc.In case of pulling out In case of pulling out0.3mm 2 ×2 cores. 48from upper leftfrom centerIn case of pulling outUpper partfrom centerLower caseL C DLower partTEMPON/OFFUpper SheathUpper SheathUpper caceUpper caceBoardBoardX YX YLower WiringLower WiringX, Y Terminal blockIn case of pulling out from In case of pulling out from centerAttach M3 screwupper leftwith washer120The peeling-off length of sheathPulling out from upper left Pulling out from centerX wiring : 215mm X wiring : 170mmY wiring : 195mm Y wiring : 190mmThe peeling-off lengthof sheathEmbedded mountingRemote control installation dimensionsWall surface120RemoteTighten the screws aftercontrol46cutting off the thin part ofoutline23screw mounting part.Wiring44Wiring oulet11.5 11Electrical box 12×7 Slot holeNot includedInstallation hole9.5×5 Slot hole 4places1 Installation screw for remote control19M4 Screw (2 pieces)Unit:mmWiring specifications(1) If the prolongation is over 100m, change to the size below.But, wiring in the remote controller case should be under 0.5mm 2 . Change the wire size outside ofthe case according to wire connecting. Waterproof treatment is necessary at the wire connectingsection. Be careful about contact failure.LengthWiring thickness100 to 200m 0.5mm 2 ×2 coresUnder 300m 0.75mm 2 ×2 coresUnder 400m 1.25mm 2 ×2 coresUnder 600m2.0mm 2 ×2 coresPJZ000Z274In case of pulling outfrom upper left83.54245120