TECHNICAL MANUAL - BVT Partners OÜ

- 41 1) - 2)'11 • SRK-T-105(5) Selection of the annual cooling function(a) The annual cooling function can be enabled or disabled by meansof the jumper wire (J172) on the indoor unit PCB and the dip switch(SW2-4) on the interface kit (optional) PCB.Interface kitJumper wire(SC-BIKN-E)(J172)SW2-4FunctionShorted ON EnabledShorted OFF DisabledOpen ON DisabledOpen OFF Disabled Jumper wire (J172)Note: (1) Default states of the jumper wire (J172) and the interface kit at the shipping from factory – On theONPCB, the dip switch (SW2-4) is set to enable the annual cooling function.OFF(2) To cancel the annual cooling setting, consult your dealer.(b) Content of control5 71) If the outdoor air temperature sensor (TH2) detects below 5°C, the indoor unitspeed is switched to 9th step. (It is not possible to change.)Outdoor air temperature ( C)'09•SRK-DB-087D2) If the outdoor air temperature sensor (TH2) detects higher than 7°C, the indoorunit speed is changed to the normal control speed.(6)Flap and louver control(a) Flap(Flap stopped)(Swing)Angle of Flap from HorizontalRemote controllerdisplayCOOL , DRY, FANHEATApprox. 5°Approx. 25°Approx. 25°Approx. 40°Approx. 35°Approx. 50°Approx. 55°Approx. 60°Approx. 80°Approx. 80°(b) Louver(Louver stopped)(Swing)Angle of LouverRemote controllerdisplayCenter installation Left Approx. 50° Left Approx. 20° Center Right Approx. 20° Right Approx. 50°(c) Swing